wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

PLTW-CEA EOC Review

Total questions: 16

Worksheet time: 47mins

Name
Class
Date
1.

A homeowner would like to improve the thermal resistance of their existing walls to reduce the heat loss in the winter. Which one of the following will most improve the home's thermal resistance?

a)

Remove the existing fiberglass batt insulation and replace with 3.5 inches of foam filled urethane insulation with an R-Value of 6.2 per inch

b)

Remove the existing wood bevel siding and replace with 1/2" thick stucco with an R-Value of 0.2

c)

Add another layer of 1/2" gypsum wall board to the inside walls with a U-Value of 2.222

d)

Remove the existing wood bevel siding and replace with 3-1/2" thick brick with an R-Value of 0.2, and 2" rigid board extruded polystyrene with an R-Value of 5.0

2.

What is the maximum deflection of the steel beam represented by the beam diagram above if w1 = 1200 lb/ft, the moment of inertia of the beam is I = 475 in.4, and the modulus of elasticity of steel is 29,000,000 psi?

a)

0.31 in.

b)

0.18 in.

c)

3.14 in.

d)

3.76 in.

3.

Using the information provided in the R-Value and Densities chart, which insulation choice has the lowest U factor?

a)

3.5 inches of batt insulation

b)

3.5 inches of rigid board polystyrene

c)

5.5 inches of batt insulation

d)

5.5 inches of rigid board polystyrene

4.

A client has provided the following requirements for a wall:

o Brings in light

o Provides an aesthetically pleasing entrance

o Gives nearly unobstructed views of countryside


Which wall will best meet the requirements?

a)

Curtain wall

b)

Tilt-up concrete

c)

Cast-in-place concrete

d)

Concrete masonry unit

5.

Which room is most likely drawn incorrectly on the (residential structure) bubble diagram?

a)

Office

b)

Bedroom

c)

Bathroom

d)

Living Room

6.

What four mineral components of a soil sample are measured and compared in order to classify a soil in the Unified Soil Classification System?

a)

Water, granules, sand, gravel

b)

Granules, silt, clay, peat

c)

Sand, silt, peat, clay

d)

Gravel, sand, silt, clay

7.

If the inside and outside air films are neglected, what is the R-value for the wall assembly shown in the diagram?

a)
b)
c)
d)
8.

Which type of beam load is shown and what is the maximum shear force?

a)

The beam is loaded with a uniform load, and the maximum shear force is (100 lbs/ft)(16 ft)/2 = 800 lb.

b)

The beam is loaded with a uniform load, and the maximum shear force is (100 lbs/ft)(16 ft) = 1600 lb.

c)

The beam is loaded with a concentrated load, and the maximum shear force is (1600 lbs/ft)/(8 ft) = 200 lb.

d)

The beam is loaded with a concentrated load, and the maximum shear force is (1/2)(100 lb/ft)(8 ft) = 400 lb.

9.

A low rise commercial building is to be built on a site where the footing will rest on a clayey gravel. Each column will carry a load of 27,000 lb. A table of soil bearing capacities is shown. Assume that concrete weighs 150 pounds per cubic foot.

Given that each concrete footing is 1’-6” thick, what are the plan dimensions for the most economical spread footing to safely support each column load?

a)

3’-0” x 3’-0”

b)

3’-2” x 3’-2”

c)

3’-8” x 3’-8”

d)

4’-8” x 4’-8”

10.

One GFI duplex outlet has been placed 6" from the edge of the cabinet on the south wall. To meet the code, how many additional GFI outlets are required for the south wall?

a)

3

b)

4

c)

5

d)

2

11.

Given the information in the table, what is the minimum R-value that will result in a total heat transmission load of 628.5 Btu/hr?

a)
b)
c)
d)
12.

Which description best describes the parcel indicated by the blue rectangle with the arrow pointing to it?

a)

Township 2 East, Range 1 North, 3rd PM, Section 32: W1/2, N1/2

b)

Township 1 North, Range 2 East, 3rd PM: S1/2, N1/2

c)

Township 1 North, Range 2 East, 3rd PM, Section 32: S1/2, NW1/4

d)

None

13.

A developer proposes to build a multistory office complex on a particular site. Which of the following would be important in determining the legality of constructing the office complex on the site in question?

a)

A review of the applicable land development regulations

b)

A review of the applicable accessibility and ADA standards

c)

A review of the applicable building code regulations

d)

A review of the applicable energy code regulations

14.

Which best describes a function of an architect?

a)

Determine the soil type in order to size the foundation

b)

Legally represent the buyer in the transaction of property

c)

Size the pipes used to bring water from the water tower to the point of use

d)

Arrange interior space in order to create efficient traffic patterns

15.

What style of architecture is often characterized by a balanced and symmetrical design, entry porch with columns, low pitched roof, fanlight over front door, double hung windows, and dentil molding, such as Thomas Jefferson’s Monticello?

a)

Tudor

b)

Federal

c)

Victorian

d)

Italianate

16.

Review the presentation of the sieve analysis results of a soil sample. After completing the table and reviewing the USCS Soil Classification Chart in the formula sheet, which of the following is most likely the correct USCS classification of the soil?

a)

GM-GC

b)

SM-SC

c)

GW-GM

d)

SP-SC