WorksheetsElectrical Technology NCCER (11th Edition) Module 1 Review
Total questions: 10
Worksheet time: 3mins
Panelboards in residential buildings are typically installed during _______.
rough-in
trim-out
service installation
planning
A residential wiring system typically uses ______.
medium-voltage cable
tray cable
flat conductor cable
nonmetallic-sheathed cable
In which of the following environments would you find a commercial electrician at work?
Shipyard
Tract home construction
Office building
Petrochemical plant
Which of the following would most likely require special knowledge of hazardous locations?
Residential wiring
Industrial wiring
Commercial wiring
Service work
A task such as motor starter repair would most likely be done by a(n) ______.
residential electrician
commercial electrician
electrical maintenance technician
electrical remodeling contractor
Minimum standards for apprenticeship training programs are established by ______.
OSHA
DOL
NCCER
the employer
The total number of on-the-job learning hours for a typical electrical apprentice program is ______.
4,000
8,000
9,000
10,000
Which of the following is true about tardiness and absenteeism?
It is never acceptable to be absent, even when you are contagious.
It is okay to be a little late for work as long as you make up the time.
If you must be absent, call in early so your employer can find a replacement.
If you are not being paid, your absence does not cost the company anything.
If you see a safety violation at your jobsite, you should ______.
ignore it unless it affects you directly
make a mental note to avoid the area in the future
report it to your supervisor
assume it is okay if no one has been injured
The primary mission of OSHA is to ______.
inspect jobsites for safety violations
fine companies that violate safety regulations
distribute safety equipment to workers
ensure that employers maintain a safe workplace
