Font size
WorksheetsEDA Quiz
Total questions: 15
Worksheet time: 75secs
Which file extension is used to save a PCB design in EasyEDA?
.pcb
.brd
.sch
.gerber
Which of these is used to connect two points in the schematic?
Trace
Route
Wire
Net
To add a new component in EasyEDA, you use the (a) tool.
What does "Auto Routing" in EasyEDA do?
Automatically adjusts the component size
Automatically places components on the PCB
Automatically connects the traces
Automatically runs the simulation
What does the "Simulation" feature in EasyEDA allow you to do?
Test the mechanical design of the PCB
Verify the electrical behavior of the circuit
Create 3D models of the components
Measure the power usage of the circuit
What does the "Footprint" in EasyEDA refer to?
The shape and size of the PCB
The electrical connections of a component
The simulation behavior of a component
The physical layout of the components on the PCB
What does "ERC" stand for in EasyEDA?
Electrical Resistor Check
Electrical Rule Check
Electrical Routing Check
Engineering Resistor Check
To add a power source to your schematic, you use the (a) component.
Which of the following layers in a PCB is used to define the copper trace that carries signals between components?
Signal layer
Ground plane
Edge layer
Silkscreen layer
In EasyEDA, which of the following is the first step to start designing a PCB?
Schematic capture
Component placement
Routing traces
Layer stacking
In EasyEDA, which of the following is NOT a valid way to place components in the PCB layout?
Using the "Component Picker"
Using the "Manual Placement Tool"
Dragging components from the "Libraries" tab
Automatically placing components using the "Auto-Place" tool
In EasyEDA, if you want to add a specific resistor value to your schematic, which of the following should you do?
Use the "Component Picker" and select the resistor component with the desired value
Manually edit the value after placing the component
Use the "Footprint Editor" to create a custom resistor
Use the "Library Manager" to search for resistors
In EasyEDA, if you need to create a custom component that doesn't exist in the component library, which tool should you use?
Library Manager
Footprint Editor
Auto-Route
Component Editor
In EasyEDA, the "Via" component is used to:
Connect power and ground planes
Provide heat dissipation for high-power components
Connect traces between different layers of the PCB
Create the copper traces between components
In EasyEDA, when you run an Electrical Rule Check (ERC), which of the following issues will it highlight?
Missing or unconnected power supply
Violations in component spacing
Traces that are too thin for high currents
Incorrect footprint sizes for components
