WorksheetsAuto Collision Repair
Total questions: 20
Worksheet time: 8mins
In a front end collision the right doors on a 4 door car need aligned.Technician A says to adjust front door 1st. Technician B says to adjust rear door 1st. Who's right?
Technician A
Technician B
Both A and B
Neither A nor B
How many layers of fiberglass mat are used on the back of a cracked SMC (sheet molded compound)repair ?
1 layer
2 layer
3 layer
4 layer
On a sheet of metal a straight file is used to:
flatten metal
find high and low spots
prepare the area for filler
sand the area
The % of hardener added to body filer is about ?
20%
5%
10%
15%
Technician A says the estimate lists parts to replace.Technician B says estimate list parts to be repaired. Who is right ?
Technician A
Technician B
Both A and B
Neither A nor B
Cold shrinking involves:
reducing the surface area of the stretched metal
increasing the surface area of the stretched metal
spreading out the surface area of the stretched metal
thinning the area of the stretched metal
Cold shrinking metal uses :
oxyacetylene torch
Mig welder
chisel
sharp pick hammer
Where can a technician find the right lifting and jacking points on a vehicle?
jacking label
lifting label
body repair manual
vehicle service manual
Technician A says all door skins are welded onto door frames.Technician B says intrusion beams are found on passenger car doors. Who is correct ?
Tech A
Tech B
Both A and B
Neither A nor B
When filing,the file will not contact:
high spots
low spots
ridges
buckles
All of the following are vehicle safety systems EXCEPT:
brakes
steering
heating
restraint
All of the following are used to retain interior trim EXCEPT:
snap-in clips
welding
push pins
small screws
Filler has been applied over paint.Tech A says its ok.Tech B says paint needs to be removed and refilled .
Tech A
Tech B
Both A and B
Neither A nor B
Tape stripes are removed with a:
grinder
DA (dual action sander)
putty knife
razor blade
What grit of sandpaper is used to first sand cured body filler?
40 grit
80 grit
180 grit
220grit
Tech A says moldings may be installed with adhesive.Tech B says moldings maybe installed with clips. Who is correct ?
Tech A
Tech B
Both A and B
Neither A nor B
All the following surfaces can be used to mix body filler except :
cardboard
glass
metal
plastic
All of the following methods are used to attach moldings except:
clips
screws
welding
adhesives
When replacing a Quarter panel.Tech A says check with manufacturer for sectioning procedure.Tech B says section where there is space. Who is right ?
Tech A
Tech B
Both A and B
Neither A nor B
Some guide coat remains after sanding.Areas with guide coat indicate:
low spots
high spots
wet spots
soft spots
