Specific guidance is given to the selection of cables, isolation, switching, and inspection and testing for electrical installations in the: ________

In high rise buildings lightning conductors must be bonded to the:

BS EN numbers relating to electrical equipment signifies compliance with British and:

Exploded views in manufacturers’ manuals are generally used to show:

An electrical contractor, compiling a list of materials and equipment required to complete an installation, will need access to:

A line on a drawing measuring 200mm, representing a wall on a site measuring 200m will be drawn to a scale of:

Where two-way switches are used as part of a lighting circuit, these switches will provide, in accordance to BS 7671:

Circuits that are used to measure and control temperature, air flow and humidity in a building are called:

Which of the following wiring systems allow for easy replacement and addition of cables?

In an installation where appearance is the most important consideration, the most likely choice of a wiring system will be:

When deciding the maximum fixing distances for conduit saddles, reference should be made to

Specialist cables and installation techniques will be required for:

Copper cored data communication cables are made up of pairs of conductors twisted along their length in order to:

A component designed to disconnect a supply under full load conditions is:

In situations where there is a risk of an explosion due to the presence of fumes and gases electrical switches and control equipment must be:

The type of earthing arrangement which generally uses the supply cable metal sheath or armouring as the earth return path is known as:

The TT system of earthing is usually used in:

An earthing system that can only be used in special circumstances and uses a combined neutral and earth conductor in the supply and the installation is the:

An isolator used to provide isolation of electrical supplies is designed to operate under:

Before commencing work on a construction site, a contracting electrician must identify:

When working on electrical circuits, the supply should be:

Inspection bends, elbows and conduit boxes should be used on long conduit runs to provide a means of:

When using metal trunking, continuity is maintained at all joints by:

Spring toggles and screws are used when fixing electrical equipment to:

Steel-wired armoured cables must be supported at regular intervals as specified in BS 7671 in order to:

After cutting and threading conduit, burrs should be removed using a:

Portable power tools should be inspected:

Holes in floors and ceilings should be restored on completion of an installation, with suitable materials and to the original thickness, in order to:

Three factors which would affect the choice of wiring system would include:

When calculations show that the voltage drop between the supply terminals and a lighting load will exceed 3% of the supply voltage, the action to be taken is:

To comply with IEE Wiring Regulations the voltage drop on a three phase 400V power circuit should not exceed:

Dangerous waste materials produced when terminating optical cables should be: