WorksheetsTools and Equipment
Total questions: 18
Worksheet time: 9mins
(True or False) This tool is an open ended spanner? Required to answer. Single choice.
True
False
What is the main job of an Axle Stand within the workshop? Required to answer. Single line text.
To support a vehicle and keep it raised safely while work is being carried out underneath.
To lift a vehicle off the ground for towing purposes.
To measure the tire pressure of a vehicle.
To clean the undercarriage of a vehicle.
You have discovered that the hydraulic jack is leaking, what should you do? Required to answer. Single choice.
Attempt to repair it as you have a set of instructions
Contact a supplier and order a new one
Report it to your supervisor
Say nothing in case your boss thinks it was damaged by you
What should you do to each wheel nut when re-fitting road wheels? Required to answer. Single choice.
Tighten using a socket wrench
Tighten in a clockwise sequence
Tighten using a torque wrench
Cover in grease to prevent rust
What type of saw is this? Required to answer. Single choice.
Combination
Long nose
Sliding jaw
Tin snips
What is the name of the tool shown in the image?
Hacksaw
Junior hacksaw
Table saw
Mitre saw
A trolley jack handle should always be left in the upright position, in order to:
Show that the jack is in use
Avoid a trip hazard
Prevent the jack from lowering suddenly
Prevent the jack from leaking oil
The reason an exhaust extractor must be used on a running engine in an enclosed space is because:
The engine may severely overheat
The noise can damage your ears
You will use the customer’s fuel
The exhaust gases are dangerous
Look at the picture and name the tool shown (refer to the diagram of screw heads labeled a to i):
Torx
Phillips
Pozidrive
Hex
Identify the equipment shown in the image below:
Angle grinder
Pillar drill
Hydraulic press
Cross plane
The equipment used to safely support the vehicle in the diagram once raised is called:
Trolley jack
Scissor Jack
Bottle jack
Axle stands
Look at the picture and name the tool shown: Required to answer. Single choice.
Open end spanner
Speed spanner
Ring spanner
Combination spanner
Look at the image of the spanner provided. What type of spanner is shown in the image?
Open end spanner
Speed spanner
Ring spanner
Combination spanner
Which tool should you use to accurately measure the tightness of a wheel nut? Required to answer. Single choice.
Torque wrench
Pipe wrench
Allen key
Adjustable spanner
What is the safest way to support a vehicle after it has been lifted with a jack? Required to answer. Single choice.
Leave it on the jack
Use a hydraulic press
Use axle stands
Place bricks under the wheels
When should you report a faulty piece of workshop equipment? Required to answer. Single choice.
As soon as you notice a problem
After trying to fix it yourself
At the end of the week
Only if it stops working completely
What safety precaution should you take before using a hydraulic jack? Required to answer. Single choice.
Place it on a slope for easier lifting
Use it without reading the manual
Apply grease to the handle
Check for oil leaks and ensure it is on a stable surface
Which of the following is NOT a type of spanner? Required to answer. Single choice.
Pipe cutter
Ring spanner
Box spanner
Open end spanner
