The process of smoothing wood surfaces using sandpaper is called ____.

The most common type of joint used in cabinet making is ____.

What is the standard size of a 2x4 lumber in inches (actual size)?

A wood defect characterized by a split along the grain is called ____.

What is used to join two pieces of wood permanently with adhesive?

Which of the following is a hardwood?

What is the first step in finishing a wooden project?

What tool is used to drive nails into wood?

The process of cutting across the grain of wood is called ____.

The main binding material used in cement mortar is ____.

A mixture of cement, sand, and water used for plastering is called ____.

Which tool is used for leveling and smoothing concrete surfaces?

The ratio for a standard concrete mix is ____.

The vertical separation between steps in a staircase is called ____.

What is used to test vertical alignment?

The process of placing concrete in its final position is called ____.

The most important component that gives concrete its strength is ____.

The removal of formwork from concrete is called ____.

The curing of concrete helps in ____.

The unit of electrical resistance is ____.

The color code for a ground wire is ____.

Which device automatically cuts off current when overloaded?

Water supply lines are commonly made of ____.

The tool used to cut metal pipes is a ____.

A device that regulates water flow in plumbing is called a ____.

Electrical power is measured in ____.

The tool used to twist or tighten wires is a ____.

Which of the following connects two pipes of the same diameter in a straight line?

Which of the following is a safety device in an electrical system?

The process of heating and shaping metal is called ____.

The joining of two metals using heat and filler material is called ____.

Which welding process uses an electric arc?

In automotive, the tool used to remove a tire from the rim is ____.

The function of engine oil is to ____.

What does “RPM” stand for?

A hand tool used for cutting metal sheets is a ____.

What part of an engine mixes air and fuel?

The battery supplies ____.

The tool used to tighten nuts and bolts is a ____.

Drafting and Industrial Safety: The line used to represent visible edges in drafting is a ____.

Drafting and Industrial Safety: The standard paper size for technical drawing in the Philippines (A3) measures ____.

Drafting and Industrial Safety: A drawing that shows a 3D object on a 2D surface is a ____.

Drafting and Industrial Safety: The protective gear for the eyes when grinding metal is a ____.

Drafting and Industrial Safety: A hard hat is worn to protect the ____.

Drafting and Industrial Safety: The safest way to lift a heavy object is to ____.

Drafting and Industrial Safety: What does PPE stand for?

Drafting and Industrial Safety: Which drafting instrument is used to draw circles?

Drafting and Industrial Safety: A safety color used to indicate danger is ____.

Drafting and Industrial Safety: In drafting, the line used to indicate symmetry is a ____.