NEW
Font size
WorksheetsDrafting and Design Concepts
Total questions: 20
Worksheet time: 10mins
What scale is commonly used for residential floor plans?
1/4" = 1'-0"
1/8" = 1'-0"
1/2" = 1'-0"
3/4" = 1'-0"
Which of the following Object Snap icons is NOT shown in the image below?
Tangent
Midpoint
Endpoint
Intersection
What features are drawn after the exterior walls?
Windows and Doors
Roof and Ceiling
Interior Walls
Foundation and Basement
Base cabinets for kitchens are drawn _____ deep while wall cabinets are _____ deep.
Base: 18″ deep, Upper: 10″ deep
Base: 24″ deep, Upper: 12″ deep
Base: 30″ deep, Upper: 15″ deep
Base: 20″ deep, Upper: 14″ deep
One method of dimensioning interior walls is to the _____?
Inside of the wall
Outside of the wall
Center of the wall
Top of the wall
Which line type is used to show an archway or plain opening on a floor plan?
Object Line
Hidden Line
Center Line
Dimension Line
The _____ opening should be shown for windows.
Rough
Smooth
Polished
Textured
Which feature/tool do the icons in the image below represent?
Object Snap Icons
Layer Management Tools
Dimensioning Tools
Block Insertion Tools
The work on the floor plan for a residence is normally started _____?
First
Last
In the middle
After the foundation
What type of information for patios and swimming pools can be included on the floor plan?
Location, Size, and Materials
Color and Texture
Shape and Design
Lighting and Accessories
Which of the following methods of showing a dimension is correct?
12" and 2'-0"
18" and 1'-6"
24" and 3'-0"
30" and 4'-0"
Using the MOVE command, you decide to move an object using the coordinates @12,-4. In this scenario, the value 12 represents _______.
The vertical distance from the object's starting point.
The horizontal distance from the object's starting point.
The total distance moved by the object.
The angle of movement for the object.
On a floor plan, the doors are drawn as the _____ door width.
Actual
Estimated
Minimum
Maximum
In manual drafting, interior stud walls with drywall on both sides may be drawn as a(n) _____ nominal thickness; however, in CADD, the actual dimension should be used.
2"
4"
6"
8"
Which type of cursor shows when one wants to pan a screen?
Arrow
I-beam
Hand
Crosshair
When using the Move command, from which point is an object moved?
Base point
Center point
Edge point
Reference point
The floor plan is actually a(n) _____?
Top Section View
Side Elevation
Bottom Plan View
3D Perspective
What type of line has no breaks or separated features?
Dashed
Dotted
Continuous
Broken
What command allows you to create a rounded curve with a specific radius between two existing lines?
Fillet
Chamfer
Trim
Extend
The room name should be lettered _____ larger than the surrounding lettering.
1/4"
1/8"
1/2"
3/8"
