Height of the tooth above the pitch circle or the radial distance between the pitch circle and the top land of the tooth.

In involute teeth, the pressure angle is often defined as the angle between the line of action and the line tangent to the pitch circle. It is termed as:

In the selection of wire rope, regular lay means wires and strands are arranged in the following manner:

Also called an eccentrically loaded bearing, it is

The property of a material that relates the lateral strain to the longitudinal strain.

The angle included between the side of the thread measured in an axial plane in a screw thread:

Flat leather belting is not recommended for use in excess of fpm.

The reciprocal of a diametral pitch, or the ratio of pitch diameter to the number of teeth.

For an evenly distributed and uniform wear on each meshing gear tooth, the ideal design practice is to consider

The changes in shape or geometry of the body due to the action of a force on it is called deformation or

The differential of the shear equation is which one of the following:

Gear used to transmit power at high velocity ratios between non-intersecting shafts that are usually, but not necessarily, at right angles.

The ratio of the moment of inertia of the cross-section of the beam to the section modulus:

Opposite direction parallel forces:

Which of the following is not a structural class of steel?

Continuous stretching under load, even if the stress is less than the yield point:

It is recommended for high-speed applications that the minimum number of teeth in a small sprocket should be:

In gear design, the ratio of pitch diameter in inches to the number of teeth is called:

The concave portion of the profile where it joins the bottom of the tooth space:

The distance of the tooth which is equal to the addendum and dedendum:

Stresses that are independent of loads:

It is used to change rotary motion to reciprocating motion:

It is recommended not to have a direct drive and sprockets if the ratio of their teeth exceeds

The motion of an object with diminished/decreased speed:

Most popular soldering material:

The following pertain to the joining of metals except:

Killed steel is always associated with

The usual ratio of water to soluble oil used as cutting fluid:

The good deoxidizer in steel melting: