NEW
Font size
WorksheetsEarthing
Total questions: 10
Worksheet time: 5mins
What is the primary safety function of an earthing system in an electrical appliance?
To increase the appliance's operational efficiency.
To prevent power surges from damaging internal components.
To provide a low-resistance path for fault current, protecting users from electric shock.
To stabilize the voltage supply to the appliance.
In conventional earthing, which materials are typically used to embed the earth plate to enhance conductivity?
Sand and cement
Clay and topsoil
Charcoal and salt
Gravel and limestone
What is a characteristic maintenance requirement for a conventional earthing system?
Periodic replacement of the earth plate.
Regular pouring of water to maintain soil moisture.
Annual repainting of the earthing chamber.
Monthly tightening of all electrical connections.
For plate earthing, what is the minimum recommended depth for burying the earthing plate from the ground level?
1 meter
2 meters
3 meters
5 meters
What is the primary function of pipe earthing in electrical systems?
To provide structural support for electrical conduits.
To dissipate fault currents safely into the ground.
To insulate electrical wires from the surrounding soil.
To enhance the aesthetic appeal of buried electrical installations.
Which combination of materials is typically used around an earthing pipe to effectively reduce earth resistance?
Sand and gravel.
Cement and water.
Charcoal, salt, and water.
Clay and limestone.
What is the recommended minimum depth for burying an earthing pipe, and what is the preferred installation method?
1 meter, by driving the pipe directly into the ground.
2.5 to 3 meters, by digging a pit and placing the pipe vertically.
0.5 meters, by laying the pipe horizontally on the surface.
5 meters, by using a horizontal trench.
Which of the following statements accurately describes Rod Earthing?
It primarily uses a horizontal copper strip buried at a shallow depth.
It is a non-treatment earthing method suitable for sandy areas or where deep excavation is impractical.
It requires extensive excavation work to install the electrode.
It is typically used for very high voltage lines and large substations.
For very high voltage lines, transformers, or substations, which earthing method is generally preferred over standard strip earthing?
Pipe Earthing
Rod Earthing
Mesh Earthing
Plate Earthing
What is considered the ideal earth resistance for an earthing system?
Less than 3 Ohms
Less than 1 Ohm
0 Ohms
Greater than 3 Ohms
