You should not handle any tools before receiving proper what?

What should be worn at all times while in the shop?

Who should check your setup before you begin working with tools?

All adjustments should be made to machines before you turn on the power.

What should you always ensure are in place in order to keep a tool safe?

It is okay to leave a power tool while it is running if you're only going to be gone for a few seconds.

What is the margin of safety while using power tools?

If a tool breaks at any point during use, what is the first thing you should do?

Long hair can be left down while using power tools.

What should be done around the shop at the end of every day?

You should remove watches, bracelets, and rings before using machinery.

What should be done with sweatshirts with strings while using power tools?

You can check the sharpness of blades by running your fingers or hands over the teeth.

In the wall framing diagram, which labeled member acts as the continuous horizontal top plate tying the studs together?

Identify framing member #11. Mark only one oval.

Identify framing member #12. Mark only one oval.

Identify framing member #13. Mark only one oval.

Identify framing member #14. Mark only one oval.

Identify framing member #15. Mark only one oval.

Identify framing member #16. Mark only one oval.

Identify framing member #17. Mark only one oval.

Identify framing member #18. Mark only one oval.

Identify framing member #19. Mark only one oval.

Identify framing member #20. Mark only one oval.

Identify framing member #21 in the wall diagram.

Identify framing member #9 in the wall diagram.

Identify framing member #10 in the wall diagram.

What is the standard spacing for studs in a wall?

What is the name for the angle of a roof?

Which way should water be stepping on a building to keep it from seeping inside?

What are the two major types of foundations?

In modern construction, brick/stone veneer is so important that walls will collapse without it.

What is the wooden (OSB) covering that goes on the outside of walls and roofs called?

Under a microscope, wood pattern looks like a bundle of straws. What is this pattern called?

What are the two major types of saws?

What is the material that gets chewed up and turned to sawdust called when making a cut?

When making a rip cut, which way are you cutting in regards to the grain pattern?

When making a cross cut, which way are you cutting in regards to the grain pattern?

A combination saw is good for making which kind of cut?

What is the unit of measurement for the coarseness of sandpaper?

What is a courser grit of sandpaper between a high and low number grit?

When sanding wood which kind of sandpaper should you start with?

When staining wood, what pattern should you apply the stain in?

About how long does it take for wood stain to dry?

What is the water based clear coat finish for wood called?

What is the oil based clear coat finish for wood called?

The tool used to cut sheet metal to rough size is called what?

The tool used to bend sheet metal into angles is called what?

What kind of shoes would be the best for a welder to wear?

What type of industrial cutting process uses oxygen and a flammable gas to make cuts?

What type of industrial cutting process uses compressed air and electricity to make cuts?

Arc welding uses a metal rod to strike an electrical arc to heat metal. What is that metal rod called?

What is MIG an acronym for?

What is TIG an acronym for?

What type of welding uses gas and a self-feeding electrode wire to make welds?

What type of welding uses a flux coated rod electrode and electricity to make welds?

Which sheet metal tool is best suited for creating straight, clean cuts across large panels?