LV01 Paper 2

Front

Which of the following tasks is not normally carried out as part of scheduled routine maintenance for a light vehicle?
Checking the operation of the lights,
Checking the condition of the tyres,
Changing the engine oil and filter,
Checking the steering geometry

Back

Checking the steering geometry

Front

Before checking the exhaust emissions of an engine you should: run the engine until it reaches normal operating temperature

Back

run the engine until it reaches normal operating temperature

Front

A vehicle protection kit consists of: a seat cover, floor mat and overalls; a floor mat, steering wheel cover and gloves; a seat cover, floor mat and steering wheel cover; a steering wheel cover, floor mat and handbrake cover.

Back

a seat cover, floor mat and steering wheel cover

Front

A tyre is outside legal limits if it has: a cut more than 25mm or 10% of the section width which exposes the casing cords, a cut of more than 1.6mm in depth anywhere on the tyre tread or the tyre casing, any part of the tread less than 0.16mm in depth measured around the tyre circumference, any part of the tread less than 0.16mm in depth measured across the tread width

Back

a cut more than 25mm or 10% of the section width which exposes the casing cords

Front

The function of the one-way clutch that is fitted to a pre-engaged starter motor is:

Back

to prevent the engine driving the starter motor if the starter switch is not released

Front

In a drum brake assembly the hydraulic wheel cylinder applies the leading brake shoe:

Back

in the same direction as the brake drum is rotating

Front

What does the term Hygroscopic mean?

Back

Absorbs water from the atmosphere

Front

In an engine lubrication system the relief valve:

Back

limits the maximum oil pressure to the bearings

Front

The legal minimum tyre tread depth for passenger cars and trailers up to 3500kg GVW is:

Back

1.6mm for 75% of the tread width for the complete circumference of the tyre

Front

A four cylinder four-stroke in-line engine has a firing order of 1342. When cylinder 1 is on the compression stroke, what is cylinder 2 on?

Back

power stroke