Hot Water 4

Hot Water 4

University

15 Qs

quiz-placeholder

Similar activities

Chapter 50 General Brakes Test Review

Chapter 50 General Brakes Test Review

University

15 Qs

Domestic hot water systems

Domestic hot water systems

12th Grade - Professional Development

15 Qs

CW - Special Components Quiz PP7

CW - Special Components Quiz PP7

University

15 Qs

Auto Tech Basics 1

Auto Tech Basics 1

8th Grade - University

20 Qs

CW - Fluid Categories Quiz PP8

CW - Fluid Categories Quiz PP8

University

12 Qs

4 stroke Outboard Engine

4 stroke Outboard Engine

University

10 Qs

Four-Stroke Engine Vocabulary

Four-Stroke Engine Vocabulary

9th Grade - University

18 Qs

Hydraulics and Pneumatics RBA

Hydraulics and Pneumatics RBA

University

20 Qs

Hot Water 4

Hot Water 4

Assessment

Quiz

Other

University

Medium

Created by

Steve Endicott

Used 452+ times

FREE Resource

15 questions

Show all answers

1.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Media Image
What type of shower is this?
Instantaneous electric shower
Thermostatic bar mixer type
Gravity fed shower
Bath mixer shower

2.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Identify one advantage of a stored hot water system in a domestic property.
There is a continual supply of hot water
It is cheaper and easier to install
It does not require a secondary source of heat
It is suitable for low water pressure areas

3.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Media Image
Which one of the following heat sources is regarded as a renewable source of energy?
Coal in a solid fuel boiler
Gas in a condensing boiler
Solar panels on the roof of a property
Electricity supplying an immersion heater

4.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Where would state the maximum flow rate and temperature for a particular pumped shower that has been installed?
BS6700
The Water Regulations
The manufacturer’s instructions
Building Regulations part G.

5.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Under Building Regulations part G, what is a new or replacement immersion heater required to have?
Temperature relief valve
Restricted thermostat to a maximum temperature of 60 degrees
Non-resetting overheat thermostat
Protective coating to avoid electrolytic corrosion

6.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Media Image
The connection for a secondary circulation system return should be made at what point in the hot water cylinder?
Bottom third of the cylinder
Top third of the cylinder
Middle point of the cylinder
Just prior to the open vent connection

7.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

If a system is prone to limescale build ups, this shows
The property is in a soft water area and the temperatures are set too high
The property is in a hard water area and the temperatures are set toohigh
The property has a gravity hot water system that requires upgrading
The water pressure in the system is too high and requires reducing.

Create a free account and access millions of resources

Create resources
Host any resource
Get auto-graded reports
or continue with
Microsoft
Apple
Others
By signing up, you agree to our Terms of Service & Privacy Policy
Already have an account?