Plasma Cutting @ EB

___________ cutting is a process that cuts through electrically conductive materials by means of an accelerated jet of hot plasma. 

• Plasma
• Oxy-Acetylene
• Oxy- Propolene
• None of the above

A super heated gas is called________

• Vapor
• Liquid
• Solid
• Plasma

The four states of matter are:______, ______,________, and _________

• Gas, Solid, Liquid, and Plasma
• Liquid, Gas, Electricity, and Plasma
• Solid, Gas, Molecules, and Lighting
• Plasma only

__________ ________ will remove the molten metal when plasma cutting

• Compressed Aluminum
• Electrified Cutter
• Compressed Air
• Presurized water

The range of PSI on our Plasma Cutter should range from  ______ to ______

• 60 to 125
• 90 to 120
• 90 to 140
• 50 to 120

The plasma cutter cutting area should be _______  and free from _____________.

• Clean + Sand
• Clean + Combustibles
• Bright + Dirt
• Wet + Clean

The compressed air going into the plasma cutter should be ________ air

• Filtered
• Oily
• Dirty
• Argon

Our Plasma Cutter can cut up to _______ material.

• 1 3/8"
• 1/4"
• 3/8"
• 3/4"

The torch tip should be held above the metal to be cut; between _____ and ______

• 1/16 and 1/8
• 1/16 and 1 inch
• 1/2 and 1inch
• 3/4" and 1 5/8

The typical amount of material removed by the plasma cutter is _______.

• 1/8"
• 1/4"
• 1/16"
• 1 inch only