Section 1 - Module 3

1. Another name for a machinist's hammer is _____.

• ball-peen hammer

• claw hammer

• veneer hammer

• sledgehammer

A heavy-duty tool used to drive posts or other large stakes is a _____.

• mallet

• sledgehammer

• bell-faced hammer

• ball-peen hammer

The proper angle for the edge of a cold chisel is _____.

• a. 90 degrees
• b. 60 degrees
• c. 45 degrees
• d. 30 degrees

The type of screw shown in the figure is a(n) _____.

• a. Phillips head
• b. Torx®
• c. Allen®
• d. Robertson®

Which of the following screws comes to a relatively sharp point at the base of its drive socket?

• a. Reed and Prince
• b. Torx®
• c. Allen®
• d. Slotted

How many sides does a hexagonal shape have?

• four
• five
• six
• seven

In what way is a spud wrench different from a pipe wrench?

• a. It is not adjustable.
• b. It has smooth jaws.
• c. It is significantly shorter.
• d. Using a handle extension is recommended.

To quickly run a nut onto a bolt that resists spinning it on with the fingers, you can drive the socket with a(n) _____.

• a. striking wrench
• b. open-end wrench
• c. speed handle
• d. breaker bar