Signal processing

Peak Meters are use to

• indicate the constant level of a signal

• indicate the transient peaks of a signal

• indicate the constant peaks of a signal

Peak Meters are use to

• indicate the constant level of a signal

• indicate the transient peaks of a signal

• indicate the constant peaks of a signal

VU meters are used to

• indicate the average constant level of a signal

• indicate the transient peaks of a signal

• indicate the constant signal of a signal

A high pass filter is

• a filter with a bell shaped curve around the filters' active frequency

• a filter with a constant level after reaching the filters active frequency

• a filter that cuts the high frequency component of a signal

• a filter that cuts the low frequency component of a signal

A low pass filter is

• a filter with a constant level after reaching the filters active frequency

• a filter with a bell shaped curve around the filters' active frequency

• a filter that cuts the high frequency component of a signal

• a filter that cuts the low frequency component of a signal

.A compressor is

• an automatic fader

• a gain control

• a device that can reduce the dynamic range of program material

• All answers are correct

Headroom is

• the level between the floor noise and the signal level

• the level between the minimum and maximum dynamic range

• the operating room between 0 db and distortion

• the area above the distortion level in a system

Which of the following is not related to dynamic level processing?

• flanger

• limiter

• gate

• expander

Reverb time (RT 60) is the amount of time it takes for a reverberated signal to reach -60db below the direct sound level.

• True

• False

What does the "Q" of a filter refer to

• resonance

• bandwidth

• resonance and bandwidth

• none