NIMS 20-43

Which government agency regulates safety and health requirements for the industry?

• Department of Health, Education, and Welfare

• Occupational Safety and Health Administration

• Department of Commerce

• Department of the Interior

A process calls for a slip or sliding fit for a 1.000” dia. shaft to fit into a hole. The clearance between the shaft and the hole should be _______________.

• .0009

• .0150

• .0001

• .0150

Which of the following is a possible remedy to remove material (solids) lodged in the eye?

• Pull the top lid over the bottom lashes

• Rub the eye from left to right

• Pull at the corner of the eye

• To seek assistance to remove the material

Long thin parts have been ground and the flatness is out of tolerance. A possible cause is:

• Machine foundation is inadequate.

• The grinding wheel is too hard.

• Cuts are too light.

• Excessive coolant was used.

If a process calls for tapping ½” – 13 NC hole using a 27/64 drill size, what percentage of thread will be obtained?

• 70% thread

• 75% thread

• 80% thread

• 60% thread

While drilling a thorough hole in a drilling operation, when is the drill most likely to grab in the workpiece?

• As it enters the workpiece.

• If coolant or oil is not used during the process.

• If you run the drill backward.

• As it breaks through the bottom of the workpiece.

A dial bore gage is used to inspect _______________.

• Surface finish

• Tapered holes

• Slots

• Holes

The most important reason for the disposal of rags and wipes after use is _________________.

• The smell they create

• The fire hazard potential

• Their appearance

• They are no fun to look at

The acronym TLV can be found on all material safety data sheets. What does this stand for?

• Time limit value

• Threshold limit value

• Time level value

• Threshold limit validity

What does the acronym MSDS stand for in a typical manufacturing environment?

• Manufacturers standard during setup

• Material safety data sheet

• Minimum standard directives for safety

• Maximum safety delivery standards