CCNA 7: Cap 1 Quiz

Which tasks can be accomplished by using the command history feature? (Choose two.)

• Recall up to 15 command line by default

• Set the command history buffer size

• View a list of commands entered in a previous session

• Save command lines in a log file for future reference

• Recall previously entered commands

Which statement describes the system LED operation on Cisco Catalyst switches?

• If the LED is amber, the system is receiving power but it is not functioning properly

• If the LED is blinking amber, the switch is performing POST

• If the LED is amber, the system is not powered on

• If the LED is blinking green, the system is operating normally

What type of Ethernet cable would be used to connect one switch to another switch when neither switch supports the auto-MDIX feature?

• straight-through

• rollover

• crossover

• coaxial

What advantage does SSH offer over Telnet?

• more connection lines

• connection-oriented services

• username and password authentication

• encryption

A network administrator has configured ​VLAN 99 as the management VLAN and has configured it with an IP address and subnet mask. The administrator issues the show interface vlan 99 command and notices that the line protocol is down. Which action can change the state of the line protocol to up?

• Configure a default gateway

• Remove all access ports from VLAN 99

• Connect a host to an interface associated with VLAN 99

• Configure a transport input method on the vty lines

Which statement describes SVIs?

• A default SVI is created for VLAN 1 for switch administration

• An SVI can only be created for the management VLAN

• An SVI is created automatically for each VLAN on a multilayer switch

Which prompt is displayed when a network administrator successfully accesses the boot loader on a switch to recover from a system crash?

• system:

• switch#

• system#

• switch:

What is the first action in the boot sequence when a switch is powered on?

• low-level CPU initialization

• load boot loader software

• load a power-on self-test program

• load the default CISCO IOS software

Which command will provide information about the status of all interfaces including the number of giants, runts, and collisions on the interface?

• show history

• show ip interface brief

• show running-config

• show interfaces