Unit 308: Woodwork machinery

Name this machine

• Rip saw

• Dimension saw

• Cross cut saw

• Chop saw

Which type of blade is this?

• General purpose

• Multi purpose

• Cross cut

• Rip saw

A Riving Knife should be ..

• Positioned at least 12mm away form the blade

• Thinner than the kerf but thicker than the body of the circular blade

• Removed if not needed

• Attached to the top guard

What is used to pre-set the dimension of a haunch when using a morticing machine?

• The vertical adjustment

• The collet chuck

• Depth stop

• The horizontal adjustment

Wood chips constantly flying out the top of a surface planer during use will indicate?

• Slow feed rate

• Fast speed rate

• Blocked or full extraction

• Blunt blades

The tracking adjustment on a narrow band saw

• Keeps the blade central on the wheels

• Prevents the blade moving from side to side

• Prevents kick back

• Keeps the blade tension correct.

The cutter block on a surface planing machine

• is square in section

• Has only one cutter

• Has limited blade protection

• is removed whilst changing the blades

What must be carried out and recorded every week on any working equipment.

• A full clean

• At least two operations per week

• A full inspection

• check the plug or switch

What document provides the service interval and criteria for a machine.

• Puwer

• Manufacturers literature

• HASAWA

• Risk assessment

Where is the lubrication applied to a mortice machine?

• Vertical adjustment

• Isolation switch

• Grease points

• depth stop