Simulacro 1

What must be presented for the pre-inspection? (Multirespuesta) (Roberto no ayuda)

• All helmet

• Steering wheel

• An unused extinguisher

• All drivers equipment

Bonded joints in the primary structure must be documented in the SES (Rafa no ayuda)

• True

• False

Vehicles must be fabricated in the accordance with the material and processes described in the SE3D (Rafa no)

• True

• False

With a “reclined driving position”, in side view the lap belt must be between an angle: (Rafa no)

• Of 70º and 90º to the horizontal

• Of 60º and 80º to the horizontal

• Of 75º and 85º to the horizontal

Which of these configuration for our driver restraint harness attachment is correct? (Multirespuesta) (Javi no)

• 1 mm wall thickness, 120m2 cross sectional area

• 2mm wall thickness, 120 mm2 cross sectional area, 8500 mm4 moment of inertia

• 2 mm wall thickness, 127 mm2 cross sectional area 8520 mm4 moment of inertia

• 2,5mm wall thickness, 119mm2 cross sectional area, 8511 mm4 moment of inertia

• 3mm wall thickness, 120 mm2 cross sectional area, 8505 mm4 moment of inetia

Does the rear wing belong to te primary structure? (Javi no)

• Yes

• No

Which of these sentences should we follow when designing our DLP? (Javi no)

• It must be fire retardant

• It must be electrical insulator

• It must be removable

• It cannot be made of steel

• It must be made of a composite material

What fire resistant one piece suit is not allowed? (Rafa no)

• SFI 3.2 A/5

• SFI 3.4/5

• FIA standard 8846-2000

• FIA standard 8850-2018

The brake pedal system must have two independent hydraulic circuits such that in the case of a leak or failure at any point in the system, effective braking power is maintained on on at leats two wheels

• True

• False

Any portion of the roll bar, roll bar bracing or chassis whic mught be contacted by the driver´s helmet must be covered with a minimum thickness of

• 12 mm

• 14 mm

• 10 mm