Carp 1 27103 RQs & TT

The most accurate level is the​ _____.

• Torpedo level

• Water level

• Carpenters level

• Line level

Antilaser eyewear should be worn when a laser​ level's output is greater than​ _____.

• 5mW

• 8mW

• 10mW

• 2mW

The type of square that is only useful for marking angles at 90 degrees to the edge is called a​ _____.

• speed square

• try square

• combination square

• framing square

The plane used to true long boards such as the edge of a door is known as a​ _____ plane.

• jack

• jointer

• block

• smoothing

The handsaw used to make very fine cuts for joinery is called the​ _____.

• Back saw

• The Advisory Committee

• compass saw

• Dovetail saw

The amount of material removed by the blade of a saw during a through cut is called the​ _____.

• kerf

• cut

• dado

• pocket

A cut that is made across the grain at an angle other than 90 degrees is called​ a(n) _____.

• bevel

• miter

• angle

• dado

The size of a table saw is determined by​ _____.

• The size of the fence

• The​ largest-sized blade it will take

• The measurement of the table

• The degree of bevel it can cut

Which of the following tasks is not commonly done with a power​ plane?

• Chamfering

• beveling

• cross cutting

• straightening

A nailer or stapler that is powered by compressed air is called​ _____.

• hydraulic

• pneumatic

• kinetic

• cordless