Haas 6.2

The X - diameter measure button is pushed to

• Measure the diameter of your workpiece

• Measure the distance from the chuck to the tailstock

• Deploy the X-ray laser system

• Record the position of the tool tip while setting a tool offset

The Z - face measure button is used to....

• Define the turret distance to the tailstock

• Set the work offset position for the machine

• Set the door swing shut position

• Determine if you've washed your hair properly

The most important thing to remember when indexing the turret...

• Check if the turret is properly aligned

• Unclamp the turret

• Rotate clockwise or anti clockwise

• Move the turret away from any obstructions

When a CNC turning centre has a crash

• Press the rewind button

• Don't inspect the turret again

• No big deal press cycle start again

• This will usually cause more damage then you think

Why is the rotational energy released in a lathe crash usually higher than a milling machine.

• Because CNC lathes are bigger

• Because there are more angled surfaces

• Because the spindle rotates quicker

• Because the workpiece is spinning in a lathe and only the tool spins in a mill

The quickest way to stop the machine in an emergency is......

• Hit the E-stop

• Press the reset button repeatedly

• Run round the machine and switch it off

• Think positive thoughts

When you push the emergency stop, what happens

• All the buttons blink and the american national anthem plays

• Alarms sound

• the machine stops moving and the program stops moving

• Machine sends message to supervisor

You should push the E-stop anytime

• You feel like you need a break and want a snack

• If you think the machine is going to crash

• If you want to pause the program

• You want to change the program to edit mode

If you need to stop the machine in the middle of a cut and the machine isnt in danger of a crash

• Press the E-stop

• Just press reset

• Press power up

• Press feed hold instead of emergency stop

If your going to work inside the machine you should press the emergency stop

• True

• False