chapter 3 GAUGES

A reference gauge is used to check___________

• Size of shafts 

• Error of gauges

• size of holes

• 90 degree angle

If the gauge is an exact copy of mating part of the component to be checked it is called___________

• Limit gauge

• Standard gauge

• Gap gauge

• Feeler gauge

A plug gauge is used to ___________

• Check the outside diameter of a work

• Check the diameter of a hole

• Measure the outside diameter of a work

• Measure the diameter of a hole

 ‘Go’ gauge tolerance zone for a plug gauge is placed___________

• Above the upper limit of hole

• Below the upper limit of hole

• Above the lower limit of hole

• Above the lower limit of shaft

The gauge used to check clearance between two surfaces is ___________

• Plate gauge 

• Gap gauge

• Position gauge

• Feeler gauge

snap gauge is used to check___________

• Size of shaft 

• Size of thread

• Size of hole

• Size of taper

A ring gauge is used to  ___________

• Check the outside diameter of  a shaft

• Check the diameter of  a hole

• Check the inside diameter of  a slot

• Measure the diameter of a hole

The gauges are used for checking the shaft’s diameter ___________

• Threaded plug gauge

• Thread ring gauge

• Thread pitch

• all of these

Taper gauges or taper feeler gauges work using the same basic principles as a typical___________

• Plate gauge 

• Feeler gauge

• Gap gauge

• none of the above

The gauge used to check clearance between two surfaces is ___________

• Plate gauge 

• Gap gauge

• Position gauge

• Feeler gauge