Fundamentals Week 8.2

Another Name for Engine Hoist:

• Overhead Lift

• A-Frame

• Cherry Picker

• Overhead Sling

• The Gravitizer

Match the following

• A-Frame Hoist

• 
• Transmission Jack

• 
• Engine Hoist

• 
• Jack Stand

• 
• My Dad Hates These

• 

Match the following

• Pit

• 
• Arm Pit

• 
• Seed

• 
• Brad

• 
• Service Pit

• 

Whats the name of the tool used to loosen or tighten the drill around a bit.?

• Key

• Chuck

• Rabbit

• Toothed Handle

• Beaver

Tech A says: When using a Die... The side with the numbers should be facing outward after installing it in the Die Wrench. Tech B says: The Die should be the same size as the bolt being cut. Who is correct?

• Tech A

• Tech B

• Both Tech A and B

• Neither Tech A nor B

Tech A says: when drilling in metal its best to use the drill at full speed. Tech B says: Even if the drill bit is cutting into the metal, its best to use some lubrication to prevent the bit from overheating. Who is Correct?

• Only Tech A is correct

• Only Tech B is correct

• Both Tech A and Tech B are correct

• Neither Tech A nor Tech B are correct

Match the Following:

• Fake Press

• 
• Bench Press

• 
• French Press

• 
• Hydraulic Press

• 
• Drill Press

• 

Match the following

• Tap Wrench

• 
• Needs a Chuck

• 
• Doesn't need a Chuck

• 
• Just Chuck

• 
• Die Wrench

• 

TTY:

(a)  

Describes the amount of twisting force allowable for a fastener for a specification showing the twisting force from an engine crankshaft , supplied by the manufacturers.

• Torque Spec

• Dyno Rating

• Horsepower

• Brake Horsepower

• Tor Limit