27/11/23

At Rangiora solo students shall make ONLY full stop landings on Runways...

• 
  04/22

• 10/28

• 07/25

SOPs regarding Engine Run-ups are...

• A full engine run-up is required before the first flight of the day and after any full crew change

• 
  Pilots are to assess the suitability of any run-up area prior to commencing Engine run up procedures and are to avoid chip seal or other loose gravel.

• A full engine run-up is required before the first flight of the day and after 50% crew change

LFZ 1 (L860) is limited to _ aircraft, no more than _ fixed wing?

• 2, 1

• 3, 2

• 1, 1

• 2, 2

What is the length of time carb heat should be applied for if severe icing is experienced?

• If icing is experienced up to 5 mins after the first application of carb heat , the carb heat should be applied for 30 seconds

• Carb heat may be permanently required and the mixture safely leaned to allow for optimum de-icing conditions. Once it is believed clear of extreme icing, richen the mixture and set carb heat to cold

• If icing is experienced between 5-15 minutes after the first application of carb heat, the carb heat should be applied for 8-12 seconds

A solo student conducting a FLWOP exercise must initiate a go-around at...

• 1500' AGL

• 1000' AGL

• 500' AGL

• 1000' AMSL

Aircraft Operations when the Ground Temperature >35°C

• No leaning of the mixture until in the cruise, or until passing 5000’ AMSL.

• On passing 1000’ AGL on departure, accelerate to the Flight Manual cruise climb speed. If no such speed is specified, add 10-15kts to the best ROC speed.

• Ensure you remain parked into the wind as much as possible to assist with cooling

• When idling on the ground use 1000-1200RPM to increase fuel and airflow to the engine to aid with cooling.