Full Volume: Lesson 3 - Check Your Understanding

What does the [Drive for] block allow Byte to do?

• Turn right

• Turn right 12 times

• Drive forward and reverse for a specific distance

• Drive forward indefinitely

What does the [Turn for] block allow Byte to do?

• Drive forward and reverse for a specific distance

• Turn for a specific number of degrees

• Drive forward indefinitely

• Turn left indefinitely

In the project below, how far will Byte drive forward?

• 12 inches

• 8 inches

• 900 millimeters

• 500 millimeters

Which of the following projects correctly codes Byte to drive forward for 300mm and turn right for 90 degrees?

Which of the following is NOT a command that can be used to control the intake on Byte?

• [Spin for]

• [Spin to position]

• [Wait until]

• [Spin]

Which of the following best describes the behaviors of Byte in the code snippet shown here?

• The intake will spin for 2 seconds to take in an object, then the arm will raise to 300 degrees.

• The arm will raise for 2 seconds to lift an object, then the intake will spin 300 degrees to release the object.

• Byte will drive forward for 2 seconds then turn right for 300 degrees.

• The intake will spin for 2 seconds to release an object, then the arm will lower to the ground.

You can use the data reported on the _____________________ to view information about the position of Byte' arm as it is moving in real time.

• VEXcode IQ Toolbox

• Settings on the Brain

• Print console in VEXcode

• Devices Screen on the Brain

Which of the following best describes the movement of Byte in the project shown here?

• The arm will lower to 0 degrees then immediately raise to 500 degrees.

• The intake will spin forward for 2 seconds then reverse for 2 seconds.

• The arm will raise to 250 degrees, wait for 2 seconds, then lower to 0 degrees.

• The intake will spin to 250 degrees, wait 2 seconds, then spin to 500 degrees.

What does the [Spin to position] block allow Byte to do?

• Spin the intake to a specific position

• Drive forward to a specific position

• Turn to a specific degree

• Drive in reverse to a specific position

What is the function of the [Wait until] command in Byte's control?

• It makes Byte wait until a certain condition is met

• It makes Byte wait indefinitely

• It makes Byte wait for a specific number of seconds

• It makes Byte wait until a specific position is reached