Section 5 Unit 1

The ___ is located at the upper left side of the engine lathe.

• Gib

• Saddle

• Leadscrew

• Headstock

the ___ may be set to a desired angle to create angular movement of the cutting tool.

• Carriage

• Compound Rest

• Cross Slide

• Saddle

On a ___ Lathe, a Small portion of the lathe bed can be removed to allow larger-diameter workpieces to be machined.

• Conversion

• Valley

• Gap Bed

• Convertible

The ___ of the lathe is determined by the biggest diameter workpiece that can be mounted in the spindle without touching the way.

• Bed

• Envelope

• Spindle Bore

• Swing

The ___ can be used to secure Workholding accessories to help support the workpiece in many operations.

• Headstock

• Swing stock

• Tailstock

• feedstock

The apron also contains the ___ knob that is used to switch between longitudinal and cross feed.

• Bull Gear

• Step Cone

• Feed Rod

• Feed Change

The ___ is a bar that spans the length of the bed and contains gear teeth.

• Apron

• Feed Rack

• gib

• Gap Rack

The ___ is a very long threaded rod supported by bearings at both ends. It spans the length of the ways and provides motion for thread cutting.

• tailstock

• Leadscrew

• Feed Rod

• Headscrew

the ___ slide is mounted on top of the saddle and provides cutting-tool movement perpendicular to the ways.

• Apron

• Compound

• Cross

• Clutch

The sliding motion of the saddle is parallel to the ways and is called ___ feed.

• Horizontal

• Longitudinal

• Vertical

• Latitudinal