Electrical Engineering Terms Set-A

In the transformers A. high tension winding is used near the core B. high tension winding is used away from the core C. low tension winding is used near the core D. low tension winding is used away from the core

Which of the following parameters can be neglected for a short line? A. resistance C. reactance B. inductance D. capacitance

The curve representing Ohm’s law is A. a parabola C. a sine function B. linear D. a hyperbola

The overcurrent protective device is caused to operate by ________ A. voltage surge C. voltage drop B. current flow D. impedance

What is the maximum number of bends permitted in rigid conduits between outlets? A. 4 quarter bends C. 2 quarter bends B. 6 quarter bends D. 3 quarter bends

Which of the following insulators will be selected for high voltage application? A. strain type C. suspension type B. disc type D. pin type

If the torque angle δ continuously increases, system will become A. stable C. oscillatory stable B. unstable D. asymptotic stable

The condition in Ohm’s law is that A. ratio V/I should be constant B. current should be proportional to voltage C. the temperature should remain constant D. the temperature should vary

Which of the following shall be included in the calculation of the reliability standard indices of the distributor asset by the Philippine Distribution Code? A. Outages that occur on the secondary lines of the distribution system B. Planned outages where the customers have been notified at least three (3) days prior to the loss of power C. Outages that occur on the primary lines of the distribution system D. Outages that occur in the transmission line

A type of electronics communication in which only one party transmits at a time. A. Full duplex C. Bicom B. Half duplex D. Simplex