HAVAL H6 HEV-001-3

What is the functional characteristics of the electronic drive axle of HAVAL H6 HEV?

• Multi-mode drive, compatible with four drive mode.

• Lightweight design, efficient and integrated design of the shift system and parking system through the shift hub.

• Shift without power interruption and design of use less lubricate fluid for DHT.

• Improve energy consumption, mainly by EV drive and supplemented by direct-drive hybrid.

Which of the technical parameter of electronic drive axle DHT is TRUE?

• DHT drive motor is using permanent magnet synchronous motor.

• Drive motor rated torque is 138Nm and peak torque is 300Nm.

• Drive motor of DHT is using liquid cooling method.

• Drive motor is using clutch to driven the torque from engine

What is the name of component A and B ?

• A: Gear Knob

  B: OBC

• A: Shifter assembly

  B: Motor controller assembly

• A: P gear shifter

  B: Inverter (DCDC)

• A: TCU

  B: DHT

What is the name of component A and B?

• A: OBC

  B: Output shaft

• A: TCU

  B: Coolant pipe outlet

• A: Drive motor controller

  B: Input shaft

• A: Drive shaft

  B: Clutch plate

What is the component name of A and B?

• A: Oil filling plug

  B: Clutch output shaft

• A: Oil drain plug

  B: Left drive shaft oil seal

• A: Shift motor

  B: Clutch temperature sensor

• A: Output shaft oil seal

  B: Temperature sensor

What is the function of P gear in vehicle?

• Use to assist in driving mode and allow transmission to change gear.

• Use to assist in parking and use mechanically lock to prevent rolling

• Use to unpowered gear and state of not transmitting power.

• Use to reversing the vehicle.

What is the function of N gear?

• Use to assist parking and use mechanically lock to prevent rolling.

• Use to assist when driving and allow transmission changing gear according to vehicle speed.

• Use to unpowered gear and transmission is not transmitting power.

• Use to assist the vehicle reversing.

Which statement is TRUE of the electronic shifter and gear display?

• When vehicle speed is more than 10km/h is not allow to enter P gear.

• When vehicle speed is less then 2km/h is allow to change gear from R gear to P gear

• If abnormal power failure the P gear required to self-learning.

• When vehicle is READY, vehicle detected driver is leaving the vehicle it will automatically enter P gear.

What is the main function of Motor controller assembly (DMCU) ?

• To control the operation of the drive motor, generator motor and equipped with a DC/DC converter.

• To increase power output in hybrid mode

• To allow energy recovery when down hill or braking.

• To control the generator to start the engine and generate electricity under the drive of the engine

What does the component included in motor controller (DMCU)?

• Drive motor controller (TMCU)

• Generator controller (GMCU)

• DC/DC converter

• TCU