Cisco Quiz # 2

Which of the following protocols are examples of TCP/IP transport layer protocols?

(Choose two answers)

• TCP

• HTTP

• IP

• UDP

• SMTP

In the LAN of a small office, some user devices connect to the LAN using a cable, while others connect using wireless technology (and no cable).

Which of the following is true regarding the use of Ethernet in this LAN?

• Only the devices that use cables are using Ethernet

• Only the devices that use wireless are using Ethernet

• Both the devices using cables and wireless are using Ethernet

• None of the devices are using Ethernet

Which of the following fields in the HDLC header used by Cisco routers does Cisco add, beyond the ISO standard HDLC?

• Flag

• Type

• Adddress

• FCS

In what modes can you type the command show mac address-table and expect to get a response with MAC table entries?

(Choose two answers)

• User mode

• Enable mode

• Global Configuration mode

• Interface configuration mode

Which of the following statements describes part of the process of how a switch decides to forward a frame destined for a known unicast MAC address?

• It compares the unicast destination address to the bridging, or MAC address table

• It compares the unicast source address to the bridging, or MAC address table

• It forward the frame out all interfaces in the same VLAN except for the incoming interface

• It compares the destination IP address to the destination MAC address

Imagine that you have configured the enable secret command, followed by the enable password command, from the console. You log out of the switch and log back in at the console.

Which command defines the password that you had to enter to access privileged mode?

• enable password

• enable secret

• Neither

• The password command if it is configured

Which of the following describes a way to disable IEEE standard autonegotiation on a 10/100 port on a Cisco switch?

• Configure the negotiate disable interface subcommand

• Configure the no negotiate interface subcommand

• Configure the duplex half interface subcommand

• Configure the speed 100 and duplex full interface subcommands

In a LAN, which of the following terms best equates to the term VLAN?

• Collision domain

• Single switch

• Subnet

• Broadcast domain

• Trunk

Which of the following port states are stable states used when STP has completed convergence?

(Choose two answers)

• Blocking

• Forwarding

• Listning

• Learning

• Discarding

Which type value on the spanning-tree mode type global command enables the use of RSTP?

• rpvst

• pvst

• rstp

• rapid-pvst