Carpentry joist, flooring and balustrade planning Quiz

What is the first step in fitting spindles for a balustrade according to the instructions provided?

• Measure the gap and divide by the number of spaces required.

• Cut to length and dry fit all of the spindles tight against one newel post.

• Apply adhesive to the spindles and set them in place.

• Sand down the spindles to ensure a smooth finish.

When calculating the spacing for balustrade spindles, what should you do after dry fitting them against one newel post?

• Paint the spindles before installation.

• Measure the remaining gap and divide by the number of spaces required.

• Secure the spindles with nails without measuring.

• Install the handrail on top of the spindles.

What is indicated by the term "Joist span" in the diagram?

• The length of the joist that is supported by the bearing wall.

• The distance between the upper and lower fibers in tension.

• The width of the joist.

• The height of the joist.

According to the diagram, where are the fibers in tension located in a floor joist system?

• At the top of the joist.

• At the bottom of the joist.

• Along the neutral axis.

• On the sides of the joist.

What is the first step in the sequence of work according to the provided material?

• Setting out

• Familiarising yourself with the task and the drawing

• Cutting timbers to length

• Laying floor joists

Which of the following is NOT a step listed in the sequence of work?

• Laying flooring and hatch access panel

• Installing electrical wiring

• Cutting and fitting newel posts

• Finishing and quality checks

What is the step that directly follows 'Fixing floor joists' in the sequence of work?

• Setting out hatch

• Laying floor joists

• Cutting timbers to length

• Handrail and spindles

What is the final step in the sequence of work as presented in the material?

• Cutting and fitting newel posts

• Handrail and spindles

• Laying floor joists

• Finishing and quality checks

According to the handrail section 1012, what is the minimum width required for stairways?

• 34 inches

• 36 inches

• 42 inches

• 30 inches

What is the minimum height requirement for guardrails on decks more than 30 inches above grade or a floor below?

• 34 inches

• 36 inches

• 42 inches

• 30 inches