Section 11 VHCL INSPCTN Quiz

Which of the following is NOT a component that needs to be checked for snugness, cracks, frays, loose fibers, or signs of wear in the engine compartment?

• Power steering belt

• Water pump belt

• Alternator belt

• Fuel pump belt

What should you look for when inspecting hoses in the engine compartment?

• Cracks and frays

• Condition and leaks

• Loose fibers

• Snugness

Where should the oil level be when the engine is off?

• Below the refill mark

• At the minimum mark

• Above the refill mark

• At the maximum mark

What should you do if the coolant level is not visible in the sight glass?

• Check the oil level

• Inspect the hoses

• Remove the radiator cap

• Check the power steering fluid

What is the correct procedure for starting a vehicle with a manual transmission?

• Place gearshift lever in neutral, depress clutch, start the vehicle, release clutch slowly

• Place gearshift lever in park, start the vehicle, release clutch slowly

• Place gearshift lever in neutral, start the vehicle, depress clutch, release clutch slowly

• Place gearshift lever in park, depress clutch, start the vehicle, release clutch slowly

What should you check to ensure the hydraulic brakes master cylinder is functioning properly?

• The level of brake fluid in the reservoir

• The snugness of the belts

• The condition of the hoses

• The oil level

What should the temperature gauge indicate when the engine is running?

• Below the normal operating range

• At the minimum mark

• Climbing to the normal operating range

• At the maximum mark

What should you check to ensure the air gauge is working properly?

• That the air compressor builds the air pressure to governor cut-out at approximately 120-140 psi.

• That the air compressor builds the air pressure to governor cut-out at approximately 80-100 psi.

• That the air compressor builds the air pressure to governor cut-out at approximately 150-170 psi.

• That the air compressor builds the air pressure to governor cut-out at approximately 100-120 psi.

What should you check to ensure the ammeter/voltmeter is functioning correctly?

• That the alternator and/or generator is charging or that the warning light is off.

• That the alternator and/or generator is discharging or that the warning light is on.

• That the alternator and/or generator is charging or that the warning light is on.

• That the alternator and/or generator is discharging or that the warning light is off.

What should you check regarding mirrors and windshield?

• Mirrors should be clean and adjusted properly from the inside; windshield should be clean with no illegal stickers, no obstructions, or damage to the glass.

• Mirrors should be clean and adjusted properly from the outside; windshield should be clean with no legal stickers, no obstructions, or damage to the glass.

• Mirrors should be dirty and adjusted properly from the inside; windshield should be clean with no illegal stickers, no obstructions, or damage to the glass.

• Mirrors should be clean and adjusted properly from the inside; windshield should be clean with illegal stickers, no obstructions, or damage to the glass.