N4/5 PWW - (Tool Box) Preparing The Blank

Why should square section material not be set up between the centres for turning?

• It is potentially dangerous

• It is too difficult to turn

• It wastes too much wood

• It takes too long to prepare

What tool is used to remove the four corners of the wood?

• A plane

• A saw

• A chisel

• A hammer

What is drawn across the corners at the end of each piece of wood to find the centres?

• Curved lines

• Vertical lines

• Horizontal lines

• Diagonal lines

What tool is used to draw a circle at each end of the piece of wood?

• A ruler

• A compass

• A protractor

• A square

What shape is drawn with its sides touching the circle at each end of the piece of wood?

• An octagon

• A square

• A pentagon

• A hexagon

What tool is used to remove the waste wood?

• A file

• A saw

• A chisel

• A plane

What tool is used to cut a diagonal groove at one end of the piece of wood?

• A plane

• A tenon saw

• A file

• A chisel

Why is a diagonal groove cut at one end of the piece of wood?

• To remove waste wood

• To make it easier to turn

• To help the drive centre prongs grip the wood

• To mark the center

What tool is used to hammer the drive centre into position?

• A hammer

• A mallet

• A plane

• A chisel

What is the final step before the wood is ready for turning?

• Drawing a circle

• Cutting a groove

• Setting up the wood in the lathe

• Removing waste wood