Basic MikroTik Configuration

What is the first step in configuring a MikroTik router?

• Connect to the router using a serial cable.

• Connect to the router using Winbox or a web browser.

• Reset the router to factory settings.

• Install a new firmware version.

How do you access the MikroTik router's interface?

• Access the MikroTik router's interface via a mobile app.

• Connect to the router using a USB cable.

• Access the router's interface through a command line interface.

• Access the MikroTik router's interface via a web browser at 192.168.88.1 or using Winbox.

What command is used to set the router's hostname?

• set hostname [hostname]

• router name [hostname]

• hostname [hostname]

• name router [hostname]

Which menu in MikroTik is used to configure firewall rules?

• Network > Firewall

• Routing > Firewall

• IP > Firewall

• IP > Security

What is the purpose of a firewall rule in MikroTik?

• To control network traffic by allowing or blocking packets based on defined criteria.

• To monitor user activity on the network without restrictions.

• To enhance network speed by prioritizing certain packets.

• To provide a backup for network data in case of loss.

How do you allow traffic through the firewall in MikroTik?

• Block all incoming traffic in MikroTik.

• Create a firewall rule with action 'accept' in MikroTik.

• Disable the firewall in MikroTik.

• Create a firewall rule with action 'drop' in MikroTik.

What does NAT stand for in networking?

• Network Access Technology

• Network Allocation Table

• Network Application Transfer

• Network Address Translation

Which MikroTik feature allows you to translate private IP addresses to public IP addresses?

• Firewall

• VPN (Virtual Private Network)

• DHCP (Dynamic Host Configuration Protocol)

• NAT (Network Address Translation)

What is the command to create a new NAT rule in MikroTik?

• /ip nat add action=masquerade chain=dstnat out-interface=

• /ip firewall nat create action=drop chain=srcnat out-interface=

• /ip firewall nat add action=accept chain=srcnat in-interface=

• /ip firewall nat add action=masquerade chain=srcnat out-interface=

How do you set up a DHCP server in MikroTik?

• Configure a static IP address manually in MikroTik.

• Use the Winbox tool to disable DHCP services.

• Set up a DNS server instead of a DHCP server.

• Use the DHCP Setup wizard in MikroTik under 'IP' > 'DHCP Server'.