Quiz on Book Binding Techniques

What is the correct thickness of the book pages for the proper wire binding technique?

• 4 - 80

• 4 - 75

• 4 - 65

• 5 - 80

• 5 - 75

Which of the following is not a sequence of operations for the wire sewing machine?

• Straightening the sewing wire inserted into the wire cutter hole

• Choosing the sewing wire

• Cutting the wire according to the thickness of the book.

• Bending the wire down, then pushing it down and into the paper below

• The wire that has penetrated the paper is held by the bending key

Which of the following is included in the wire sewing machine equipment?

• Wire

• Needle

• Clamping Head

• Thread

• Ruler

What is the main tool in the wire sewing machine, which consists of a pressing block, a bender, and a cutter?

• Wire

• Needle

• Clamping Head

• Bending Key

• Wire Guide

The process of cutting the wire for the sewing machine is adjusted according to the thickness of the book to be sewn. The cut wire is bent into the shape of ...

• I

• L

• S

• U

• V

What are some mistakes that may occur when using the wire sewing machine?

• The right leg is too short because the bending angle is worn out and needs to be replaced

• The right leg is too short because the wire is too short

• The right leg is too short because the bending key is not tight enough.

• The right leg is too short because the bending key is not tight enough.

• The clamping leg is not tight enough because the bending key is not tight enough

The wire cutting knife is dull, the wire is too thin, not suitable, just like if the right leg is bent, if both legs are bent, the wire being too thin is a mistake that will cause ...

• The left leg is too short

• The corner part is damaged

• The wire breaks at the top

• Only one leg is bent

• The left leg is bent

For thick or regular binding work, thin wire is used.

• Thin small

• Thick small

• Flat small

• Flat thick

• Flat thin

Which of the following is not a step/method for sewing the spine system?

• Adjusting the distance of the book thickness using a regulator

• Installing the wire roll used and adjusting it to the thickness of the book.

• Cut the spine of the book

• Cut the end of the wire

• Insert the end of the wire through the wheel that regulates the length of the wire to be cut towards the clamping head.

The tool that is not used in binding notebooks with the spine system using a wire sewing machine is ...

• Hammer

• Glue

• Pliers

• Screwdriver

• Ruler