Which of the following is not in the code of conduct policy?

• Being aware of British Values

• Being Helpful towards others

• Mobile phones are not to be seen or heard

• Always smile

Which of the following is not measured on Behaviours?

• Works diligently

• Communicates clearly

• Intelligence

• Positive and respectful attitude

What are the dangers of working on electrical equipment?

• Electric shock, Burn, Fire, Arcing, Explosion

• Electric shock, Water, Flames, Sparks

• Costly Repairs, Confusing, Heavy Fines

• Competence, Regulations, Guidebook, Law

Who would issue a Permit to work?

• The person in charge of the work

• An authorised engineer

• The persons carrying out the work

• An independent person

Risk assessments ensure that workplaces monitor any changing conditions by:

• recording all minor accidents

• recording all serious accidents

• reviewing hazardous situations

• reviewing visitor book

Written procedures that inform an employee of how a task is to be undertaken are known as:

• risk assessment

• permit to work

• method statement

• COSHH statement

When carrying out safe isolation procedures for the purposes of safety, which of the following should be used?

• neon screwdriver

• a multimeter

• Approved Voltage Tester

• Volt Stick

The Electricity at Work Regulations require that:

• only persons who have the appropriate level of knowledge and experience can work with electricity

• only duty holders can work with electricity

• only time served electricians can work with electricity

• only supervised apprentices can work with electricity

Electrical safety is best achieved by:

• isolating and securing the supply

• switching the supply off

• working during quiet hours

• wearing electrician’s gloves

Which of the following is correct regarding safe isolation and investigating an electrical fault?

• begin investigation, verify circuit is dead, isolate and lock off, re-check voltage device

• obtain permission, check voltage device, verify circuit is dead, re-check voltage device, begin investigation

• begin work, lock off, verify circuit is dead, re-check voltage device, begin investigation

• obtain permission, isolate and lock off, check voltage device, verify circuit is dead, re-check voltage device, begin investigation