SET A

An electricians should always have his tools in good working condition, the most important reason being is _.

• You have to exert more effort when using defective tools

• Your job cannot be satisfactory done without good tools

• It is part of your job to keep tools in good working condition

• Defective tools can cause accidents or damage to equipment

What type of hand tools commonly used of ½ diameter hole in a panel board

• Cold Chisel and a hammer

• Hacksaw and Hammer

• Knock out Puncher and Adjustable Wrench

• Hand drill

It is the connection between the grounded circuit conductor and the equipment grounding conductor at the service.

• Bonding jumper

• Grounding electrode conductor

• Bonding jumper, main

• Bonding jumper, equipment

What is the fitting commonly used for lightening between the boxes and RSC conduit?

• Straight Connector

• Condulet

• Conduit strap

• Lock nut and bushing

Part of the Auxiliary system that set the motion-trigger action individually for each camera

• Live Previewing

• Recording

• Camera Scheduled

• Motion Detection

A live duplex wire can be de-energize quickly and safely by cutting __________?

• Across with an electrical pliers

• Across using a mechanical pliers

• One by one with a knife

• One by one using diagonal cutter

When measuring load current, an ammeter is connected __________?

• Parallel with the load

• In series with the load

• Across the terminal of the load

• From one load terminal to ground

When measuring load resistance, the ohmmeter is connected __________?

• Parallel with the source

• series with the load

• Across the terminals of the load

• From one load terminal to ground

What is the ampacity of 8.0 sq. mm. THW wires?

• 35 amperes

• 20 amperes

• 25 amperes

• 50 amperes

What will you do if the load schedule reflects a 20AT/2.0 sq. mm. lighting branch circuit of which circuit breaker is over rated?

• Wait for your superior and let him do the connections

• Look for another load schedule and check for differences

• Look for the wiring lay-out and check groupings

• Change rating to 15AT to conform with PEC requirement