(GSIUR Regulations) E,F and G Mock Exam

Which of the following is a requirement for any work done on a gas appliance?

• The appliance must be examined after work has been done, and any defect notified to the owner/user.

• The appliance must be painted after installation.

• The appliance must be used immediately after installation.

• The appliance must be installed by two people.

Why should gas engineers ensure that any appliance they install or connect is safe for use?

• To comply with regulations and ensure no danger to any person.

• To increase the speed of installation.

• To reduce the cost of installation.

• To make the appliance look better.

What should appliances be installed in accordance with, according to Regulation 26?

• Manufacturers’ instructions, including instructions on flues.

• The engineer’s personal preference.

• The color of the kitchen.

• The cheapest available method.

If a gas appliance is left connected to the gas supply but cannot be used safely, which regulation is being violated?

• Regulation 25 and 26.

• Regulation 10.

• Regulation 50.

• Regulation 1.

Under Regulation 26(5), when is it acceptable to leave a gas appliance connected to the gas supply after installation?

• When the appliance is new

• When the appliance can be used safely or is sealed off from the gas supply with an appropriate fitting

• When the appliance is under repair

• When the appliance is not in use

What is required before installing a gas appliance without a means of shutting off the gas supply at the inlet, according to Regulation 26(6)?

• The appliance must be brand new

• The provision of such means is not reasonably practicable

• The appliance must be portable

• The appliance must be electric

Which of the following is considered an appropriate means of shutting off the gas supply to an appliance, as per Guidance 26(6)?

• A plastic cap

• A conventional isolation valve or a self-sealing plug-in connector

• A rubber stopper

• A wooden block

Which of the following is NOT one of the immediate examinations required after performing work on a gas appliance, as per Regulation 26(9)?

• The effectiveness of any flue

• The supply of combustion air

• The color of the appliance casing

• The operation to ensure safe functioning

Which of the following is NOT covered by regulation 26(9) regarding gas appliances?

• Work on gas appliances

• Work on gas meters

• Work on appliance burners

• Work on appliance data badges

What does regulation 26(9)(ca) address?

• When there is no meter or meter display to directly measure the heat input

• When the appliance is under warranty

• When the appliance is used outdoors

• When the appliance is electric