NEW
Font size
S
M
L
XL
WorksheetsAg. Mech II Comp 16 and 17 Test
Total questions: 34
Worksheet time: 17mins
Name
Class
Date
1.
What type of tractor is designed to offer increased traction and pulling power?
a)
Four wheel drive
b)
Lawn and garden
c)
Orchard and grove
d)
Utility
2.
Which type small tractor is made to use around the home or in parks?
a)
Lawn and garden
b)
Row crop
c)
Standard wheel
d)
Tracklayer
3.
The two major types of tractors are:
a)
Green and red
b)
Large and small
c)
Purchased and leased
d)
Wheel and crawler
4.
What type tractor is made for planting cotton and corn?
a)
Lawn and garden
b)
Low clearance
c)
Orchard and grove
d)
Row crop
5.
Which is a small tractor that is popular with apple and orange growers?
a)
Crawler
b)
Four wheel drive
c)
Lawn and garden
d)
Orchard and grove
6.
To learn safety rules before using a tractor, what should be done?
a)
Check tractor advertisements
b)
Contact National Safety Council
c)
Read farm magazines
d)
Read operator's manual
7.
The best way to prevent power takeoff (PTO) accidents is to:
a)
Engage PTO while standing behind the tractor
b)
Inspect the shaft we it first starts moving
c)
Keep the shield guard in place
d)
Wrap the PTO shaft with chicken wire
8.
A tractor with a front end loader may tilt forward if a heavy load is attached:
a)
Too high
b)
Too low
c)
To the drawbar
d)
To the rear axle
9.
More than one person riding on a tractor at the same time is:
a)
Safe
b)
Too heavy
c)
Unsafe
d)
Too light
10.
What should be attached to the rear of a tractor or other farm equipment that usually goes less than 25 miles per hour?
a)
Farm equipment sign ahead
b)
Second rider to direct traffic
c)
Slow moving vehicle emblem
d)
Wide load sign
11.
Checking the water and cleaning the radiator on tractors and other self-propelled equipment are preventive maintenance for the:
a)
Cooling system
b)
Electrical system
c)
Fuel system
d)
Lubrication system
12.
Two simple maintenance procedures done before starting a 4-cycle engine are:
a)
Add antifreeze and water
b)
Add oil an fuel mixture
c)
Change spark plugs and points
d)
Check oil and add clean fuel
13.
Cleaning the outside parts of a small engine is the MOST important maintenance for the:
a)
Cooling system
b)
Fuel system
c)
Electrical system
d)
Lubrication system
14.
It is very important that dust and dirt be kept out of small engines because they do NOT have a/an:
a)
Amperage gauge
b)
Battery
c)
Oil filter
d)
Oil gauge
15.
The primary reason for all types of preventive maintenance on tractors, equipment, and small engines is to:
a)
Decrease repairs
b)
Increase costs
c)
Reduce efficiency
d)
Increase repairs
16.
Checking the engine oil level is a service NOT necessary for:
a)
2 cycle engines
b)
4 cycle engines
c)
Combines
d)
Tractors
17.
To service an "oil filter" type air filter, the filter is washed to remove the dirt and then
a)
Discarded in trash can
b)
Oiled and squeezed
c)
Repaired by the technician
d)
Replaced with a new one
18.
Changing the oil is the MAIN service done on a 4-cycle engine's
a)
Coolant system
b)
Electrical system
c)
Exhaust system
d)
Lubrication system
19.
A new model small engine will NOT have:
a)
A piston
b)
A spark plug
c)
Pistons
d)
Points
20.
When on is servicing a "dry type" air filter, the filter should be
a)
Blown out
b)
Oiled
c)
Repaired
d)
Replaced
21.
One of the MOST necessary services for batteries is:
a)
Adding oil
b)
Adding water
c)
Oil cables
d)
Replacing cables
22.
What engines require that points and condenser be replaced?
a)
Larger
b)
Newer
c)
Older
d)
Smaller
23.
Oil filters should be changed when:
a)
Air filter is changed
b)
Antifreeze is changed
c)
Fuel filter is changed
d)
Oil is changed
24.
Replacement of the oil filter on a tractor engine should be done each time:
a)
Antifreeze is added to the tires
b)
Coolant is added to the radiator
c)
Engine oil is changed in the tractor
d)
Tire air pressure is checked
25.
The MAIN service to a spark plug is to:
a)
Oil
b)
Paint
c)
Repair
d)
Replace
26.
If a chain saw is to be stored for the summer, the fuel tank should be:
a)
Empty
b)
Full
c)
One fourth full
d)
Three fourths full
27.
When trouble shooting an engine that will not start what is the first thing that should be checked?
a)
Fuel supply
b)
Piston rings
c)
Oil level
d)
Water level
28.
To find the compression specifications for an engine before measuring the compression, what should a mechanic do?
a)
Call the factory
b)
Consult service manual
c)
Guess or estimate
d)
Talk with service manager
29.
If an engine that will NOT start has fuel in the tank, what is the next trouble- shooting procedure?
a)
Check fuel supply at carburetor
b)
Check valves and piston rings
c)
Replace air, fuel and oil filters
d)
Replace starter and battery
30.
If there are no problems with the fuel or the battery, but the engine will not start, what should be the next step in trouble shooting?
a)
Add antifreeze
b)
Change oil
c)
Check spark
d)
Check valves
31.
What three things should Ted check as he begins trouble shooting an engine that will not start?
a)
Fuel, ignition, and compression
b)
Gasoline, oil, and starter
c)
Spark plugs, points, and condenser
d)
Water, battery, and key
32.
What is the first thing that should be checked when trouble shooting a 2 cycle engine that skips or misses?
a)
Battery
b)
Fuel mixture
c)
Starter
d)
Water level
33.
If an engine has fuel and compression but will not start, what is the likely problem?
a)
Ignition
b)
Oil
c)
Rings
d)
Water
34.
If an engine will NOT "turn over" when the operator tries to start it, the first step in trouble shooting should be to check the:
a)
Battery
b)
Fuel
c)
Spark plug
d)
Water
Reset
