Wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Brakes and Handling Day 2

Total questions: 15

Worksheet time: 8mins

Name
Class
Date
1.

Why do ABS modules use redundant microprocessors?

a)

To compare and validate data

b)

To process data more quickly

c)

To handle more data

d)

To compare and select the best data to use

2.

Select all that apply. The ABS light remains on after its brief self-test during startup. What does it mean?

a)

There is a fault stored, but ABS will intervene during certain traction events

b)

The conventional braking system will have reduced functionality

c)

There is a fault stored, and ABS will not intervene during traction events

d)

The conventional braking system remains fully operational

3.

Understeer occurs when the vehicle turns abruptly and cannot be corrected even though the driver attempts to turn the vehicle straight again

a)

True

b)

False

4.

Oversteer occurs when the front wheels continue to travel in a straight line even though the rear wheels are moving.

a)

True

b)

False

5.

Select all that apply. Which are true about progressive steering?

a)

It has a more powerful electric motor

b)

It has different sized straight-cut teeth to vary steering travel

c)

It has fewer teeth to increase steering travel at lesser steering angles

d)

It has variable teeth on the steering rack

6.

A customer states that the ASR/ESC lamp flashed briefly last week on a curvy road, but there are no faults stored. What is the most likely cause?

a)

The ABS module is faulty because it didn't store faults

b)

The ESC module is faulty because it didn't store faults

c)

There was a traction event and the system operated normally

d)

There are mismatched tires on the drive axle(s)

7.

A customer states that when using the electro-mechanical parking brake, the light in the switch turns off after about 30 seconds when the ignition is switched off. What is the most likely cause?

a)

It's normal operation

b)

It's on terminal 30, so there has to be a short to terminal 31 on the ground side

c)

It's on terminal 30, so there has to be a short between terminal 75x and power

d)

It's on terminal 50, so this is normal

8.

Except Touareg, what happens when the electro-mechanical parking brake switch is operated above 7km/h?

a)

The electro-mechanical parking brake gradually applies to operate as an emergency brake

b)

Nothing. The electro-mechanical parking brake switch is deactivated above 7km/h

c)

The electro-mechanical parking brake applies abruptly to operate as an emergency brake

d)

ESC will intervene and operate as an emergency brake

9.

What happens when an AUTO HOLD precondition is no longer met?

a)

There are no preconditions

b)

The electro-mechanical parking brake engages

c)

The seatbelt warning lamp is illuminated

d)

The Airbag Control Module (J234) is deactivated

10.

When AUTO HOLD first activates, the vehicle is held in place by the hydraulic brake system.

a)

True

b)

False

11.

What happens when AUTO HOLD is active for more than 3 minutes?

a)

The system switches from the hydraulic brakes to the electro-mechanical brakes

b)

The ABS module overheats from the continuous running of the hydraulic pump (V156)

c)

The wheel speed sensor trigger wheels are engaged with parking pawls

d)

It deactivates at the 3 minute mark, be prepared!

12.

How does Indirect Tire Pressure Monitoring detect low tire pressure if all tires are equally low?

a)

It can't because the it uses only wheel rotation comparisons

b)

There is a back-up Direct TPMS sensor that is activated after approximately 40 revolutions are not seen by the Indirect system

c)

Using the 3rd law of PFM

d)

Software in the ABS Control Module detects changes in harmonic resonance captured by the wheel speed sensors

13.

Select all that apply. Which are true statements about Dynamic Chassis Control (DCC)?

a)

It uses only a complex mechanical system to make adjustments

b)

Dampening profiles cannot change until the vehicle is completely stopped

c)

It also adjusts braking and steering profiles

d)

It uses an electronic worm-gear type piston

14.

What is the term for vibration that causes the steering wheel to move in the direction of the arrows in the image?

a)

Shimmy

b)

Shudder

c)

Shake

d)

Drone

15.

Which signal is what an inductive wheel speed sensor would produce?

a)
b)
c)
d)