Font size
WorksheetsBasic Static Machines 2
Total questions: 15
Worksheet time: 8mins
Choose 3 occasions you use a push stick
Never there to awkward
When your fingers will be to close to the blade
To avoid cutting your fingers off
To push unit through when ripping a narrow piece
A relief cut is
Gee I'm glad I didn't cut my hand off
Not necessary when cutting curves
The removal of waste material to allow easier access for a cutter or blade.
A Bow in timber is
A hollow that may be found in the length of timber material along the face
A great hunting tool
An oval shaped piece of timber
A device to hold a drill bit
A Kerf is select 2
term for ripping
A concrete edge strip
A small groove, specifically the width of the cutting blade
A small groove made consecutively to help bend timber
A Spring in timber is
A hollow that may be found in the length of material along the edge
Found along the face of the timber
Great to make a diving board out of.
A small groove made the thickness of the blade
If you where to Tailor out
You would be getting measured up for a suit
You would be feeding the material into the machine
You would supporting the material on the outfeed side of the material
You would run from infeed to outfeed tables like a crazy man
The Arbor is
Metal shaft or axel on which a cutter block or saw blade is fitted
Is a person who looks after trees
It should be spelt harbour: it's a large body of water
Does the same thing as the riving knife
If I was Ripping a piece of timber I would be
Cutting it across the grain
Cutting it with a chisel
Sawing along the grain
If I was docking a piece of timber. Choose 3
Cut across the grain
Hold timber firmly against the fence
Make sure the rip fence is not in the way
Cut along the grain
If cutting white melamine board you should
Only cut it by hand
Always use the scribe blade
Don't use the scribe blade
Wear a dust mask
Red gum and Blackwood are. Choose 2
Very soft timbers easy to machine
Very hard on cutters and blades
Hardwoods
Great tasting bublegum
Victorian Ash
Is found in QLD
Is full of shanks and no good for machining
Is quite knotty
Has a straight grain and is easy to machine
When ripping on a bowed piece of timber
The external part of the round should be away from the fence and table
The external part of the round should be against the fence and table
Regular machine maintenance will
Waste time and slow production
Ensure less breakdowns and therefore less loss in production time
Stop you from cutting your hand off
Increase Down time by machine breaking down
Streaking is
Blemishes on the sanded surface caused by a clogged belt
How many streaks you get on snap chat
When a streaker runs out at the cricket
Colouring in
