Font size
WorksheetsBasic Static Machines 3
Total questions: 15
Worksheet time: 8mins
What should you do before using any basic static machine
Nothing just start using it stop wasting time
You need to make sure everything is prepared and safe to use
Get a mate check it for you
Go have smoko
A panel planer or thicknesser
Is used to flatten the timber face and edge
To reduce timber to a required width or thickness parallel to a planned face and edge
Is used to rip a piece of timber
Is used to dock the timber
A Surface Planner / Buzzer
Machines timber to a required thickness
Docks the timber to size
Rips the timber
Prepares a face and edge on the timber
Cross cut / Docking saw
Is good for curve cutting
Used to accurately drill holes
Rough docking to length, trenching, angle cutting or squaring to a given length
When changing the cutter on the Spindle Moulder you should. Select 2
Always put the blade behind the fence
Always put the blade on a piece of ply or cardboard
Drop the cutter, it's pretty tough
Always put it in front of the fence
When changing blades on the thicknesser or buzzer you should. Select 2
Run your finger along the edge to see if it is sharp
Take note of it's positioning before you take it out
Tighten blades where it easiest to get to
Place a piece of ply over the cutter to avoid slipping and cutting your hand
What is the most accurate way to measure the bandsaw blade
Guess
Measure the wheels and times it by 2.5
Measure the width of wheel and triple it
Take the blade off, cut it and measure with tape measure
The bottom wheel on the bandsaw
Is only a guide
Drives the Blade
Can be adjusted to make sure the blade runs true
Sets the tension of the blade
The top wheel on the bandsaw. Select 2
Sets the tension of the blade
Adjusts the tracking of the blade
Drives the bandsaw
Would be good to put on your bicycle
Name the guard
Mutton guard
Crown guard
Hood guard
Bridge guard
Name the guard
Hood guard
Crown guard
Mutton guard
Bridge guard
This is a surfacer
True
False
When feeding a large quantity of material through spindle moulder. What could help feed it through
Push stick
Clamps
Automatic feed rollers
What would be the appropriate storage for cutters and blades
On the floor as long as there out of the way
In a cupboard free from moisture
Outside in a timber container
Wherever you want
This is a
Thicknesser
Spindle moulder
Bandsaw
Drill press
Surfacer
