Font size
WorksheetsElectrical Circuit
Total questions: 95
Worksheet time: 4hrs 27mins
Why is electrical wiring usually made from copper?
Because copper is shiny
Because copper conducts electricity
Because copper is not magnetic
Because copper insulate electricity
Which of the following materials is an electrical conductor?
Plastic spoon
Silver-colored plastic spoon
copper spoon
wooden spoon
What is a circuit that only has ONE path for electricity to flow?
series circuit
closed circuit
parallel circuit
light bulb
What is a circuit with several paths for electricity to flow?
conductor
series circuit
parallel circuit
open circuit
Why is electrical wiring usually are covered with a layer of plastic?
To make it look pretty
To help electricity flow along the wire
To make it safe
To add more energy
How many light bulbs would be ON with this complete circuit?
(a)
How many light bulbs would be ON if the wire of this circuit was cut where the scissors are?
(a)
How many light bulbs would be ON if the wire of this circuit was cut where the scissors are?
1
3
2
0
True or False: A wooden block would allow electricity to flow through it because wood is a great conductor of electricity.
True
False
Formula: Work= force x distance
Joules= Newtons x meters
What is the equivalent or total resistance (Re) across this circuit?
3 kΩ
10 kΩ
13 kΩ
18 kΩ
How would the equivalent resistance be determined?
1 / Req = (1/5) + (1/8) + (1/3) Ω
120 Ω
1.5189873 Ω
1 / Req = (1/5) * (1/8) * (1/3) Ω
The equivalent resistance in this circuit is (a) ohm
the formula to find current when the values of V and R are known is
I = V2R
I = V/R
I = R/V
I=VR
If a circuit has two resistors in series both are 4Ω, the total resistance of the circuit is (a) ohm
If a circuit has two resistors in parallel both are 4Ω, what is the total resistance of the circuit?
1Ω
2Ω
4Ω
8Ω
in which circuit is the lamp brightest
1
2
3
All the same
in which circuit is the lamp brightest
1
2
3
All the same
Which resistor has the biggest voltage across it?
2 Ω
3 Ω
4 Ω
all have the same
If the current through a circuit is 2 A and the resistance of a light bulb in the circuit is 10 Ohms, the voltage difference across the light bulb is (a) volt
You do 90 joules of work in 30 seconds. The power have you generated is (a) watts
If the cell provides 12 volts and there are four identical bulbs, each bulb will use (a) volts.
The table describes four different resistance wires.
They are all made from the same metal.
Which wire has the smallest resistance?
A
B
C
D
Which symbols are used for the units of current and of resistance?
A
B
C
D
The current in the wires of a circuit is 120.0 milliAmps. If the battery was replaced by one with double the voltage (with no other replacements), then its new current would be _____ milliAmps.
60 milliAmps
120 milliAmps
240 milliAmps
No way to tell
The voltage of the battery is 8 volts. If the current must double but the light bulb is remaining the same, the battery must be replaced by one with ____ volts
16 volts
8 volts (the battery voltage won’t change)
4 volts
More information is needed
In a series circuit, how is the brightness of a light bulb affected when another bulb is connected?
It gets brighter
It stays the same
It gets dimmer
It goes out
Which of the following is a resistor?
What is a resistor?
An electrical component that produces light
An electrical component that helps to limit current, divide voltage and produce heat
An electrical component that produces sound
An electrical component that generates power supply
Which of the following is a series circuit?
What is the power in Watts of a 20V bulb with 5A of current flowing through it?
The voltage dropped across the 300 ohm resistor is (a) volt
What is the definition of electrical current?
The opposition to the flow of electrons
The rate of flow of charge
The work done on each coulomb of charge
Electrons moving around
When more light bulbs are added they all remain bright.
Unit for current is (a)
