WorksheetsTools and consumables safety
Total questions: 12
Worksheet time: 6mins
Which of these checks would be made to a copper and hide hammer? there could be more than one.
Date of expiry
Loose Head
Split handle
Mushroomed head
One type of safety check to make to any plug in mains electricity equipment is?
Check for year of manufacturer
Check for the installers stamp
Check the plug and cable for condition
Check it runs at full speed
Which of the following would not be a check for a garage product supplied in a can?
check for leaks
check for sharp edges
check for cracked glass
Check for product warning labels
Which of these substances give of dangerous vapours?
WD 40
engine oil
copper grease
Tyre patch adhesives
What is this equipment called?
Sight glass
Reflectometer
Hydrometer
Refractometer
Safe use of product information can be found on:
Side of container and manufacturers safety data sheet
Workshop manual and Autodata
Risk assessments and COSHH book
Workshop wall chart
What does WD stand for and what is it used for?
Wet and Dry used for protecting glass
Water desiccant used to dilute water
Water displacer, used to penetrate and lubricate siezed components
Water droplets used to corrode mechanical components
Which of the following oil lubricates, penetrates and cleans for general use.
1 in 3 oil
31 oil
3x1 oil
3 in 1 oil,
What is this equipment used for?
checking tracking
checking Camber
Checking head light aim
checking bonnet alignment
State two faults that should be checked on this tool
Gone soft and bent
Bent and twisted
Splits on head and blunt tip
Head protrusion and twisted tip
Mole grips are used to grip and hold components, which is the correct image?
Where would you use this grease?
On the brake pedal
On the metal contact points of pads and shoes
On the lining material to prevent wear
To top up the brake reservoir
