WorksheetsCCNA Test-4
Total questions: 10
Worksheet time: 5mins
(config)#router ospf 1
In this command what does the number 1 refer to?
Autonomous system number
Router Id
Interface No
None of the above
Which two parameters in the hello packet need to match on OSPF routers to form adjacency?
Router Id
Hello and Dead Intervals
Authentication password
Neighbor
Which host matches the network 176.4.16.0 with a wildcard mask 0.0.15.255?
172.4.6.7
172.4.32.253
172.4.30.255
172.4.40.4
Give two reasons for preferring Named ACL over Numbered ACL.
Easy to identify the function of the ACL
Named ACL can filter using port numbers
Easy to replace a line in the ACL using sequence numbers
TCP protocol is used in named ACL
Router(config)#encapsulation dot1q 4.
In this command what does the number 4 refer to?
vlan id
subinterface id
physical interface id
None of the above
Which combination would not form an etherchannel bundle in LACP?
Active-Active
Active-Passive
Auto-Auto
Passive-Passive
What is the command to verify the NAT translations on the Cisco router?
show ip translation
show ip nvi
show ip nat translation
show ip interface translation
Based on the information given which switch will have all its ports as designated?
SW-C
SW-D
SW-B
SW-A
Which flavour of STP is Cisco proprietary and supports load balancing across vlans?
PVST+
CST
RSTP
ISL
The STP port on which BPDUs are received is
Designated Port
Backup Port
Root Port
Trunk Port
