Font size
WorksheetsAEM71- Create a setup sheet CNC Mill 2
Total questions: 20
Worksheet time: 31mins
In the following image the name of part 8 is
Milling table with T-slots
Vice
tool changer
Milling head
In the following image the name of part 4 is
Milling table with T-slots
Vise
tool changer
Milling head
In a milling machine in addition to the linear movement along the X, Y and Z-axes, it is possible to control rotation around each axis. These controllable rotation axes are marked
with
X, Y ,Z-axes , V,U and W.
U, V and W-axes.
X, Y and Z-axes.
A, B and C axes.
The first procedures to switch on the CNC milling machine is
Launch the control software
Open air supply
Open and close the chip guard door once for checking the door safety switch.
Regulate pressure (5 to 6 bars)
The CNC milling machine Main Control Key to run the program in the air above the part without actually cutting is
1
2
3
4 & 5
The CNC milling machine Main Control Key to start and stop the program is
1
2
3
4 & 5
The CNC milling machine Main Control Key to move your milling cutter manually is
1
2
3
4 & 5
The CNC milling machine Main Control Key to approaching the reference point in all axes
1
2
3
5
Which of the following modes allow direct entry of the programming codes and parameters in CNC milling
Auto Mode
Override Mode
Jog Mode
MDI mode
In the following CNC program work piece dimensions are
55 x 10 x 30
80 x 50 x 16
90 x 280 x 80
40 x 30 x 15
In the following CNC program clamping device dimensions are
55 x 10 x 30
80 x 50 x 16
90 x 280 x 80
40 x 30 x 15
In the following CNC program work piece material is
High stainless steel.
Copper
HSS
N\Aluminium
In the following CNC program tools used are
Shell end mill cutter.
End Mill Rough HSS
Twist Drill HSS.
Dovetail cutter.
In the following CNC program which tool is active
Shell end mill cutter.
End Mill Rough HSS
Twist Drill HSS.
Dovetail cutter.
In the following CNC milling program the dimensioning system used is
Angular.
Absolute.
Incremental.
World coordinate system.
In the following CNC milling program the spindle speed is
90
1500
400
200
In the following CNC milling program the feed rate is
90
1500
400
200
In the following CNC milling program the depth of cut is
2 mm
2 inches
8 mm.
8 inches.
In the following CNC milling program hole depth is
10 mm
10 inches
8 mm.
8 inches.
In the following CNC milling program corner fillet size is
10 mm
10 inches
5 mm.
5 inches.
