Font size
WorksheetsArchitectural Drawing
Total questions: 40
Worksheet time: 30mins
Which part of a church is often made of stained glass?
Door
Altar
Patio
Window
What is the minimum width for the area that the toilet is in?
12"
24"
36"
48"
In a set of house plans, which plan will tell you the location of the house on the site?
Plot plan
Foundation Plan
Electrical Plan
Plumbing Plan
What is not the purpose of a green home design?
To grow green plants
Environmentally friendly and sustainable
Efficient use of energy, water, and building materials
Produce less waste
What is the name for an architectural drawing of a building's exterior?
Plan
Elevation
Facade
Section
In a set of house plans, which plan will show you all of the doors, windows, walls, and patios?
Site Plan
Floor Plan
Landscape Plan
Patio Plan
What term is described as usually near the house but not structurally connected to it ordinarily located at ground level and constructed for durability?
Gazebo
Deck
Patio
Court
Which New York building was the tallest building in the world in 1940?
Flatiron Building
Empire State building
Twin Towers
Brooklyn Museum
The function and efficiency of the rooms will be enhanced by using a(n) _______________ where the dining room and living rooms are not closed off from each other.
Open floor plan
Single plan
Closed plan
Raised Floor
Straightedges that have a short crosspiece at one end.
Parallel Bar
T Scale
Mini Drafter
Technical Scale
Semicircular instrument for measuring and plotting angles.
Protractor
Triangles
French Curve
Compass
The quintessential element of architectural drawing.
A Ruler
Pencil
A Line
Paper
Rules equipped with system of cables and pulleys that allow their straightedges to move across the drawing board only in a parallel manner.
T Scale
Digital Stylus
T- Square
Parallel Bar
A tool with graduations along its edges so that scale drawings can be measured directly in feet and inches.
Ruler
Template
Architect's Scale
Digital Scale
A tool with cutouts of various shapes and sizes to confine the area of a drawing to be erased.
Eraser
Erasing Shield
Compass
Template
What guides the drawing of irregular curves through a series of points.
Compass
Protractor
French Curves
Triangles
Symbol number 6 shown on the floor plan represents
Water Closet
Lavatory Sink
Toilet
Shower
When dimensioning architectural plans, which is the symbol for a "foot" measurement?
'
"
ft
Foot
What is a term used in building codes to describe access?
Egress
Doors
Entry
Casing
Dashed lines that follow the counters in a kitchen floor plan most likely represent,
Trash compactor
Upper (wall hung) cabinets
A valance
A dishwasher
A "half bath" would include,
Water closet and lavatory
Shower, water closet, and lavatory
Tub, water closet, and lavatory
Any of the above
What is the accepted method of writing a measurement of "six inches" on an architectural drawing?
1/2'
0.5'
6"
0' 6"
Which symbol below represents a dishwasher?
A
B
C
D
Symbol number 7 shown on the floor plan represents...
Hinged door
Bi-folding door
By-passing door
Double-action door
Which is an accepted symbol for a brick veneer wall?
A
B
C
D
Architectural dimensioning is usually done in ________.
Even Numbers
Feet and Inches
Feet only
Inches Only
The building construction industry relies on sets of ________ drawings to construct homes and commercial buildings.
Mechanical Drawings
Axonometric Drawings
Isometric Drawings
Architectural Working
The site plan illustrates ________.
the floor plan
where the house sits on the property
the roof plan
where the garage and driveway are located
Who is responsible for the accuracy of the working drawings set?
Draftsman
Contractor
Drafting Equipment
Client
What is the dimensions of an A0 sheet?
594mm x 841mm
23.4 x 33.1 in
900mm x 600mm
841 x 1189 mm
10 inches is equivalent to
10 cm
25 cm
25.4 cm
100 mm
What is the angle between the hour hand and the minute hand of a clock at 3.30?
60'
75'
90'
80'
Architectural drawings are used mainly for,
to communicate ideas and concepts
to assist a building contractor to construct it based on design intent
as a record of the design and planned development
all of the above
none of the above
What is this?
Drawing in a black sheet
Whiteprint
Blueprint
Hand drafted working drawing
Which of these are true about Architectural Drawings?
may include tones or hatches to emphasise different materials
are intended to appear realistic.
intended to explain a scheme
to promote its merits
Which one of the following type is NOT a part of Working drawing set?
Electrical Drawings
Axonometric Drawings
Perspective Drawings
Foundation Drawings
Site Plan
What is the Cross in the drawing denote?
Western Closet
Jacuzzi
Indian Toilet
Shower
What is this?
Foundation Drawing
Ceiling Plan
Plumbing Drawing
Floor Plan
In perspective projection, all lines of sight start at a ________point.
Multiple
Two
Single
Triple
These are points at which the edges of the object appear to be converging.
Stationary Point
Vanishing Point
Vertical Point
Perspective Point
