In a _________ transfer mould design the resin is heated and liquified in a transfer chamber provided in the mould.

In pot transfer moulding ___________ is the heated and liquified in a pot.

In a _______ transfer mould the material is injected by an auxiliary ram.

The _________ is the part of the upper section of the pot transfer mould, which forces the liquid resin into the cavity.

In plunger transfer moulding the clamping force will be _________ of the total force.

In transfer moulding the gate should always be as small as possible so that the _________ mark is less.

The ____________ should be as short as possible to minimize the flow restrictions.

Vents are used for removing entrapped __________.

In transfer mould design, air removal is possible through __________.