_______ is the transfer of heat within a fluid, that is a liquid or gas. It is caused by a mixing action within a fluid.

The following is the correct order of energy conversion in thermal power plants

In thermal power plant, turbine is placed

In thermal power plants, the dust of flue gases is trapped by

The path of flue gases in Thermal power plant is

The following is not a component of Thermal power plant

For steam boilers, the fuel(s) is (are) mainly

The thermal efficiency of a steam power station is.......

The draught produced by the chimney if due to the ____ difference between the column of hot gases inside the chimney and the cold air outside.

The major heat loss in a steam power station occurs in ........

The cost of fuel transportation is maximum in........

The boiler commonly used in a thermal plant are__________________.

Steam is classified as

Why is high-quality steel used to make boilers

What forces are a boiler subjected to during operation

It is defined as a component in the plant cycle that consists of a closed vessel that uses the heat produced by the combustion of fuel to efficiently vaporize and convert water into steam at the desired temperature and pressure.

________is the transfer of heat through a solid object, or between two objects, as a result of physical contact.

It is an extremely high-temperature vapor generated by heating the saturated steam obtained by boiling water.

_______ is the transfer of heat within a fluid, that is a liquid or gas. It is caused by a mixing action within a fluid.

The three ingredients needed to start a fire are fuel, heat, and ___.

Which type of boiler should not be used for high pressure steam applications

This boiler has flue gasses passing around the tubes and water flowing through the tubes

What is created by the boilers at the power plant?

Air preheater is used to preheat air with the help of ______

The following is the correct order of energy conversion in thermal power plants

In thermal power plants, the dust of flue gases is trapped by

The following is not a component of Thermal power plant

The draught produced by the chimney if due to the ____ difference between the column of hot gases inside the chimney and the cold air outside.

The primary function of a combustion control system is to regulate the ___ in a boiler.

An operating pressure control must be connected to the ___.

The two settings found on the boiler operating pressure control are used to ___.

boiler water is treated to prevent...

hardness is a measure of scale forming __ dissolved in water

boiler water having high alkalinity could develop ___

a direct cause of overheating of the boiler tubes is ___

A boiler that has water around the tubes and flue gasses inside the tubes?

Steam Boilers must be blown down daily due to formation of this that drops out of the water when it is turned to steam

This is a Byproduct of incomplete combustion?

___ draft is created by a draft fan that pulls the gases of combustion through the furnace.

Pressure at the discharge side of a forced draft fan is ___ atmospheric pressure.

___ compounds are classified as a pollutant because they react with water vapor to form sulfuric acid.

Mechanical draft is produced by ___.

Mechanical draft can be classified as ___.

The induced draft fan is located ___.

Mechanical draft is used when burning ___.

A ___ draft system is used to overcome air and gas-flow resistance

The oldest form of draft used in a boiler is ___ draft.

Boilers can be equipped with ___ to reduce the heat loss from the gases of combustion going to the chimney.