WorksheetsASE Quiz
Total questions: 26
Worksheet time: 13mins
One of the vehicles' brake lights is an operative. All other lights are functioning normally which of the following should be checked first?
The battery
The brake light switch
The bulb
The circuit’s fuse
A hydroboost brake system has a hard brake pedal and reduced breaking performance which of the following would be result in this condition?
Aerated brake fluid
A leaking vacuum check valve
A faulty vacuum pump
Aerated power steering fluid
The TPMS warning light goes out after driving the vehicle for several miles the most likely cause of this condition is.
An out of round tire
Low tire air pressure
A weak TPMS sensor battery
A faulty wheel speed sensor
A rear wheel drive vehicle with an automatic transmission has a vibration that increases with vehicle speed. There is a loud clunk when the transmission is shifted from park to drive or reverse. Which of the following is causing this condition?
an out of round tire
An unbalanced drive shaft
Loose and worn universal joints
Loose flywheel bolts
An oil filter has ballooned on a 4 cylinder engine. Technician a says a stuck closed oil filter bypass valve would cause this swelling. Technician B says a stuck open oil pressure valve would cause this swollen filter. Who is correct?
Technician A
Technician B
Both A&B
Neither A or B
A vehicle's engine is slow cranking the 12 Volt battery passes all test and is in good condition which of the following should the technician test next?
The starter motor
The starter circuit
The battery state of charge
The charging system
A technician is unable to balance a tire on a vehicle that vibrates at speeds above 40 mph. Each time the tire is spun a weight must be added to a different location on the rim. Which of the following is most likely causing this condition?
The tires belt is separated
There is liquid inside the tire
The TPMS sensor is shifting
The tires trade is cupped
View the illustration above and choose the correct answer below.
The item in the illustration protects suspension components from metal to metal contact
The item in the illustration fits over strut inserts
Both A&B are correct
Neither A or B is correct
There is a clunking and popping sound coming from the front of the vehicle that only occurs when turning. Which of the following is causing this condition?
Loose rod ends
A faulty power steering pump
Weak coil Springs
Worn brake pads
A FWD vehicle drifts to the left at all speeds. Technician A says a misaligned engine cradle results in this condition. Technician B says loose motor Mount results in this drift. Who is correct?
Technician A
Technician B
Technician A and B
Neither Technician
A front wheel drive vehicle has four new tires installed. The left front wheel has a grounding sound that increases with vehicle speed. Which of the following is most likely causing this condition?
A Cupped tire tread
A feathered tire tread
A worn CV joint
A faulty wheel bearing
A vehicle pulls to the left only while braking. Which of the following is causing this pull?
A restricted left front brake line
A frozen right front caliper
Both A&B
Neither A or B
A vehicle's air conditioner blows warm while sitting at rest. It returns to normal at cruising speed. All of the following will result in this condition EXCEPT
A faulty fan clutch
A weak electric cooling fan motor
A weak blower motor
Debris on the condenser fins
A technician runs a scan and receives a fault code indicating a problem in the MAF sensor circuit. Technician A says this could be caused by a loose wire or an intermittent open. Technician B says this could be caused by a faulty mass air flow sensor. Who is correct?
Technician A
Technician B
Both A and B
Neither A or B
An engine is admitting blue-gray exhaust from its tailpipe only when it is first started. The exhaust smoke goes away after the engine runs for a few minutes. Which of the following is most likely causing this blue-grey exhaust?
A blown head gasket
A leaking intake manifold
A leaking fuel injector
Leaking valve seals
The battery is overheating and the headlights shine brighter when the engine is revved to 2500 RPM. Which of the following would be the cause of this condition?
A high capacity battery
A faulty voltage regulator
A loose accessory belt
Halogen headlamp bulbs
Which of the following is least likely to cause a vehicle with power rack and pinion steering system to bind while turning corners?
Bad strut Mount bearing
Worn tie rod ends
A faulty rack and pinion gear
The lower ball joint
While bleeding air from a hydraulic power steering system the technician should perform each of the following steps Except .
Raise both front wheels in the air.
Turn the steering wheel from stop to stop to bleed air from the system.
Hold the wheel for at least 10 seconds at each steering stop.
Flush the system with manufacturer recommended power steering fluid.
While performing an initial inspection the technician noticed a red colored fluid between the transmission and the engine. Which of the following is correct?
The fluid is a result of leaking rear main seal
The fluid is a result of a leaking transmission pump seal
This fluid is a result of a leaking camshaft seal
The fluid is in a result of a leaking crankshaft seal
The electrical symbol shown is a
Splice
Variable resistor
Fuse
Diode
There is white colored exhaust emitting from the tailpipe of a vehicle. Which of these could be the cause?
It has worn piston rings
It has a leaking head gasket
He has worn valve seals
It has a leaking fuel injector
An automatic transmission fluid is pink and Milky technician a says that this is a result of an engine overheating. Technician B says the transmission may be overfilled and the fluid has become aerated. Who is correct?
Technician A
Technician B
Both A and B
Neither A or B
Technician A says fuel filters have an arrow that always points towards the fuel tank. Technician B says a clogged fuel filter will reduce fuel pressure at the fuel rail. Who is correct?
Technician A
Technician B
Both A and B
Neither A or B
Which of the following is true about the tire in the illustration
It is underinflated.
It is overinflated
There is too much camber
The coil spring on that wheel is weak
A vehicle with power assist brakes has a hard brake pedal with little little stopping. Which of these is MOST likely causing this condition?
The brake booster
The master cylinder
Air in the system
Contaminated brake fluid
A technician measure several spots around the rotor with an outside micrometer. Technician A says the technician is checking the rotor for thickness variation. Technician B says the technician is checking the rotor for lateral runout. Who is correct?
Technician A
Technician B
Both A and B
Neither A or B
